Panasonic SC-BT303, SC-BT200, SC-BT203 warranty Frequently asked questions, Messages, Setup, SD card

Page 52

Messages

On the unit’s display (continued)

Page

“[W1]” is flashing.

≥There is no link between this unit and the wireless system. Check that the wireless system

45

(when using the optional wireless

is plugged into the household AC outlet and is turned on.

45

accessory: SH-FX70)

≥Ensure that the digital transmitter is fully inserted into the slot of this unit.

 

≥If the wireless system is not used, disconnect the digital transmitter from this unit.

—

U59

≥The unit is hot.

—

 

The unit switches to standby for safety reasons. Wait for about 30 minutes until the

 

 

message disappears.

 

 

Select a position with good ventilation when installing the unit. Do not block the cooling fan

 

 

on the rear of the unit.

 

U72

≥The HDMI connection acts unusually.

—

U73

– The connected equipment is not HDMI compatible.

 

 

– Please use HDMI cables that have the HDMI logo (as shown on the cover).

 

 

– The HDMI cable is damaged.

 

Hor F

≥Check and correct the speaker cable connections.

9

(“ ” stands for a number.)

≥There is something unusual. (The service number displayed after H and F depends on the

—

 

unit’s condition.)

47 to 50

 

≥Check the unit using the troubleshooting guide. If the service number does not disappear,

 

do the following:

 

 

1 Disconnect the plug from the household AC outlet wait a few seconds, then reconnect

 

 

it.

 

 

2 Press [POWER Í/I] to turn the power on. (The unit may be fixed.)

 

 

If the service number does not disappear despite doing the above, request service from

 

 

the dealer. Inform the dealer of the service number when requesting service.

 

IPOD OVER CURRENT ERROR

≥The iPod is drawing too much power. Remove the iPod, and turn the unit off and on again.

—

 

 

 

START

≥The system is being restarted during the firmware update. Please do not turn off power.

32

 

 

 

UPD/

≥The firmware is being updated.

32

 

 

 

FINISH

≥The firmware update is complete.

32

NOT CONDITIONAL

≥The requested operation cannot be conducted.

—

 

 

 

llllllll

≥The main unit could not save the modified settings. Some settings may need to be reset.

—

 

 

 

Frequently asked questions

 

 

Setup

 

Page

 

Can I connect other speakers?

≥Speakers other than those supplied cannot be used. This system achieves ideal audio

—

 

 

properties through the combination of the main unit and the supplied speakers. Using

 

 

 

other speakers may damage the system and will not produce correct audio characteristics

 

 

 

(e.g., no bass sounds).

 

 

My TV has COMPONENT VIDEO IN

≥The different levels of picture quality input are listed below in order from highest to lowest.

—

 

terminals and HDMI IN terminal.

HDMI IN )COMPONENT VIDEO IN )VIDEO IN. However, it will take longer for the

 

 

Which should I connect with?

picture output to start up when this unit is connected with the HDMI IN terminal.

 

 

 

 

 

 

Disc

 

 

 

Can I play BD-Video and DVD-Video

≥You can play them if the video standard is NTSC; however you cannot play:

Cover

 

bought in another country?

– BD-Video discs that do not include region “A”.

 

 

 

– DVD-Video discs that do not include region “1” or “ALL”.

 

 

 

Refer to the disc’s jacket for more information.

 

 

Can BD-Video/DVD-Video that does

≥The region management information for BD-Video/DVD-Video indicates that the disc

—

 

not have a region code/number be

conforms to industry standards. You cannot play discs that do not conform to industry

 

 

played?

standards or do not have a region code or number.

 

 

Please tell me about disc compatibility

≥Refer to “Disc and card information” and “About MP3/JPEG files”.

42, 44

 

with this unit.

≥You cannot write to a disc with this unit.

—

 

SD card

 

 

 

What kinds of operations are available

≥The following operations are available.

—

 

on the SD card slot on this unit?

– Play back JPEG data recorded with a digital camera etc.

 

 

– Play back AVCHD motion pictures recorded with Panasonic High Definition Video

—

 

 

Camera

—

 

 

– Play back MPEG-2 motion pictures recorded with Panasonic Standard Definition Video

 

 

Camera

22

 

 

≥If a BD-Video disc supporting BD-Live or BONUSVIEW is used, it is possible to copy

Reference

 

secondary video, etc. from the Internet or disc to the card and play it back together with

 

 

the images on the disc, etc.

 

 

 

 

 

 

 

 

 

What kinds of cards can be used?

≥SD Memory Cards (from 8 MB to 2 GB), SDHC Memory Cards (from 4 GB to 32 GB),

43

 

 

miniSD Cards*, and microSD Cards* can be used.

 

 

 

* A miniSD Card and a microSD Card must be used in the adaptor included with the

 

 

 

memory card.

 

 

 

Please confirm the latest information on the following website.

 

 

 

http://panasonic.co.jp/pavc/global/cs

 

 

 

(This site is in English only.)

 

RQT9508

52

Page 51 Page 53
Image 52
Page 51 Page 53
Contents Region management information If you have any questions contactBD-Video DVD-Video ExampleAccessories If you see this symbol FCC NoteFollowing Applies only in the U.S.A Following Applies only to the U.S.A. and CanadaTable of contents Control reference guide remote control Preparing the remote controlBatteries UseStandby/on switch Power Í/I Control reference guide main unitFront panel Rear panel terminalsSpeaker assembly option Assembling the speakersPreparation Preventing the front speakers from fallingSetup example PositioningIf irregular coloring occurs on your TV Do do Not TipsSetup example Speaker connectionsSheet of speaker cable Speaker cable for front Front speaker LTV connections Connections with a video cableOptional connections Video OUTNecessary Settings Connections with a component video cableConnections with an Hdmi cable HdmiConnections to a Set Top Box, etc ≥Do not connect through the video cassette recorderSTB, VCR, DVD recorder, etc Press EXT-IN several times to select D-IN 2 DigitalUsing an FM/AM outdoor antenna optional Radio antenna connectionsAC power supply cord connection Broadband Network ConnectionsPress OK to finish the Smart Setup / Easy Setup Basic settings for the systemBT300 \BT303\ BT200 Preparation Press Í to turn on the unit Press Start Showing Start menuPress 3, 4 to select the item and press OK Selecting the source with the remote control Press 3, 4 to make the settingSelecting the playback source Selecting the source from the Start menuAdjusting speaker level during play Enjoying sound from all speakers and various sound effectsChanging the sound modes Enjoying surround sound effectsVOL Press to adjust the volume Basic operationsPress Í to turn on the unit Insert the media. B see above Press to mute the soundBasic operations Search Search Search/Slow-motionOK Frame-by-frame Chapter playback DVD-VRPlaying video recorded on a Video Camera or Video Recorder Enjoying BD-LIVE or Bonusview in BD-Video Enjoying BD-Live discs with InternetInsert an SD card Insert the discPlaying still pictures Insert a disc or an SD cardPress 3, 4, 2, 1 to select the album and press OK Press 3, 4, 2, 1 to select the still picture and press OKPlaying still pictures Useful functions during still picture playPlaying music continuously even after turning off power to Playing musicInsert a disc Press 3, 4 to select the track and press OKListening/confirming the preset channels Setting up the radioListening to the Radio Adjusting the sound Making settings for digital audio inputAvailable settings Press Status several times to select ModeSetting the TV audio for Viera Link Hdavi Control Linked operations with the TVWhat you can do with Hdavi Control Speaker controlEasy control only with Viera remote control Using the iPod IPod ConnectionEnjoy music/video Extended mode Press iPod to select Ipod Enjoy photos Simple modeSwitch the TV input to video Press 3, 4 to select an item and press OKEnjoying Viera Casttm Firmware updatingPress BD/SD to select BD/DVD or SD Press Viera Cast Press 3, 4, 2, 1 to select the item and press OKNetwork settings Testing of IP Address/DNS SettingsSetting the IP address Setting the DNS-IPNetwork settings On-screen menu operations Changing settings with the on-screen menuWhat you can change with the on-screen menu Changing settings with the on-screen menu PlayVideo AudioChanging the unit’s settings Setup menu operationsSummary of settings Press BD/SD to select BD DVD or SDDisplay Changing the unit’s settingsDTS/DTS-HD TV / Device Connection Others NetworkDST Speaker settings Adjusting the sound lag between speakersDelay time Volume Channel balancePackaged discs Disc and card informationRecorded discs Disc and card handling MaintenanceTo dispose or transfer this unit Structure of folders that can play back on this unit About MP3/JPEG filesMP3 Jpeg Making the wireless link Wireless connections optionalConnections Attaching to a wall Front BT300, BT303 speakerInsert the cable From the bottomTroubleshooting guide To reset this unitPower OperationDisplays Troubleshooting guideTV screen and video Optional wireless system SH-FX70 SoundCard IPod operationsOther difficulties with playback On the TV MessagesOn the unit’s display Frequently asked questions SetupMessages SD cardLanguage code list LicensesBD-J GlossaryDTS-HD MPEG4 AVC/H.264 Viera CastSpecifications Playable disc BD-VideoBD-ROM Version DVD-R/DVD-R DLDVD-RW CD-DA CD-R/CD-RW CD-DA, JPEG*6, MP3Panasonic Home Theater Limited Warranty Limited Warranty Only for U.S.A. and Puerto RicoCentralized Factory Service Center Product Service Limited Warranty only for CanadaPanasonic Canada Inc Index
Top Page Image Contents