50CHAPTER 5: TROUBLESHOOTING
Illegible Characters | If the system operates normally after the system runs the POST, the | |
Display on the | information is displayed on the console terminal. If the configuration system has a | |
Terminal after | fault, the terminal may display only illegible characters. | |
| If the console terminal displays illegible characters after the POST, verify that the | |
| ||
| HyperTerminal parameters are set properly, as follows: | |
| ■ | Baud: 9600 |
| ■ | Data bits: 8 |
| ■ | Stop bit: 1 |
| ■ | Parity: None |
| ■ | Flow control: None |
| ■ | Terminal emulation: VT100 |
| If the parameter settings do not match these values, reconfigure them. | |