DISPLACEMENT PUMP
Reassembly Procedure
1.Stack the backup washer (219*), U±cup seal (205*) lips down, and female gland (220*), alternate the polyethylene and leather v±packings (217*, 218*) lips up, and stack the male gland (213*) one at a time onto the piston valve (224). See Fig 15.
2.Tighten the packing retaining nut (214) onto the piston valve (224) and torque to 3±4 in±lb (0.34 ± 0.35 N.m). See Fig 13.
NOTE: NOTE THE ALIGNMENT of the piston (224) to the nut (214). Maintain this alignment through- out Steps 2, 3 and 4.
|
| 203* | |
214 | APPLY ONE DROP | ||
TORQUE NUT TO | OF SEALANT TO | ||
THESE THREADS | |||
| 3±4 | ||
(0.34±0.35 N.M) |
| ||
|
| NOTE AND MAINTAIN | |
|
| THIS ALIGNMENT | |
|
| THROUGHOUT STEPS | |
|
| 3,4, AND 5 | |
Fig 13 |
| 224 | |
| |||
8.Assemble the intake valve. Use a new gasket (206*). Screw the valve into the cylinder and tighten to 80 ft± lb (107 N.m). See Fig 15.
9.Screw down the cylinder locknut (112) until it is finger tight at the bottom of the external cylinder threads. See Fig 15.
10.Install the displacement pump on the sprayer. See page 16.
223 
201
221
112
*212 
218*
Lips must face down
*209 |
|
Lips must | 211* |
face down |
3.Apply 1 drop only of sealant, supplied with the repair kit, to the piston valve threads. Place the small ball (203*) on the valve. See Fig 13. Hand tighten the valve into the rod (223) just until the nut contacts the rod. Place the flats of the displacement rod in a vise.
216
203*
APPLY 1 DROP OF ADHESIVE (in repair kit)
TO THESE
THREADS
223
214
213*
214 | *208 |
TORQUE NUT AGAINST ROD | Lips must face up |
TO 19 |
|
217*
Lips must face up
DO NOT ALLOW THIS NUT TO
MOVE RELATIVE TO THE
PISTON (224) WHEN
INSTALLING PISTON ONTO ROD
Fig 14
4.Torque the nut (214) against the rod (223) to 19 ft±lb (25 N.m). Use two wrenches to maintain the align- ment as mentioned in the NOTE. See Fig 14.
5.Stack the male gland (211*), alternate the polyethyl- ene and leather v±packings (218*, 209*) lips down and stack the female gland (212*) one at a time into the top of the cylinder. See Fig 15.
6.Loosely install the packing nut (221) and plug (201).
7.Insert the oiled piston rod (223) into the bottom of the cylinder.
*205
Lips of seal must face down
224
*207 
215
*204 
*206
Fig 15
220*
219*
222
TORQUE TO 80 ft±lb
(107 N.m)