Graco 249377, 288217, 249369 important safety instructions Flush Spray Gun, Position Air Cap

Setup

KEY

N Cylinder Air Inlet: accepts 1/4 in. (6.3 mm) O.D. tubing

P Atomization Air Inlet: 3/8 in, (9.5 mm) O.D. tubing

R Fan Air Inlet: 3/8 in. (9.5 mm) O.D, tubing

S Fluid Inlet: 1/4 npsm

T Fluid Outlet (circulating gun only): 1/4 npsm

Side Mounted Manifold Ports

N

T (or S) S (or T)

FAN ATOM

CYL

TI8096a

RP

Bottom Mounted Manifold Ports

N

R	FAN	ATOM	P
		CYL
T (or S)			S (or T)
			TI8097a

FIG. 10: Manifold Ports

Flush Spray Gun

Before running any paint through the spray gun:

1.Flush the gun with a solvent that is compatible with the fluid to be sprayed, using the lowest possible fluid pressure and a grounded metal container.

2.Perform Pressure Relief Procedure; see page 17.

Position Air Cap

Air caps are factory-set with the alignment pin (A) set to a vertical spray pattern. To change the air cap to a hori- zontal spray pattern, use a needle nos pliers to unscrew the alignment pin (A) and relocate it to the horizontal spray pattern hole. When relocating the pin use low strength thread locker. Torque to 1.5-2.5 in-lb (0.2-0.3 N•m). Do not overtighten. Refer to FIG. 11.

TI8171a

Vertical Pattern

A

TI8170a

TI8172a Horizontal Pattern

FIG. 11: Position Air Cap

14 311051F