Graco Inc ti14916a, 3A0243A Tighten latch and rotate latch lock into locked posi- tion

Page 25

5.Rotate pump to align with material hose. Connect material hose and hand tighten to 70 in-lb.

ti6299a

6.Tighten latch and rotate latch lock into locked posi- tion.

ti6204a

TI6312a

ti6312a

ti6204a

Displacement Pump

7. Attach drain hose to sprayer.

ti14909a

8.Fill pump with Graco TSL until fluid flows onto top of seal.

ti5493a

3A0243A

25

Image 25

Contents Related Manuals Operation 3A0242 Parts 3A0244 Gun Korean patentFire and Explosion Hazard Pressurized Aluminum Parts Hazard Pressure Relief Procedure MaintenancePremium Sprayers Engine Oil Funnel Problem Cause Solution TroubleshootingThroat packing nut just enough to stop leakage Fluid Pump Runs Constantly Troubleshooting ProcedureControl Board Malfunction Step Control Board Malfunction StepsConvertible Electric Motor Will Not Run Step Convertible Electric Motor Will Not Run StepsSee step Is there over 10-20 AC volts? Beep Two blinks is the same as E=02 Digital Display MessagesInstallation Bearing Housing and Connecting RodRemoval Relieve pressureDrive Housing Pinion Assembly Pinion Assembly/Clutch Armature/ClampClutch Armature Installation Clutch Housing Engine Pressure Control Pump ON/OFF SwitchControl Board Pressure Adjust PotentiometerPressure Control Transducer Do Pressure Relief, Displacement PumpPlace u-bolt on pump door protrusion Tighten latch and rotate latch lock into locked posi- tion Hose Reel Grease shaft Install E-clip Pivot Replacement Technical Data Dimensions 3A0243A For Graco Canada Customers Graco Standard Warranty