Troubleshooting
Troubleshooting
Problem | Cause | Solution |
|
|
|
|
|
|
E=XX is displayed | Fault condition exists. | Determine fault correction from table, page 14. |
Engine will not start | Engine switch is OFF. | Turn engine switch ON. |
|
|
|
| Engine is out of gasoline. | Refill gas tank. Honda Engine Manual. |
|
|
|
| Engine oil level is low. | Try to start engine. Replenish oil, if necessary. |
|
| Honda Engine Manual. |
|
|
|
| Spark plug disconnected or damaged. | Connect spark plug cable or replace spark |
|
| plug. |
|
|
|
| Engine is cold. | Use choke. |
|
|
|
| Fuel shutoff lever is OFF. | Move lever to ON position. |
|
|
|
| Oil is seeping into combustion chamber. | Remove spark plug. Pull starter 3 to 4 times. |
|
| Clean or replace spark plug. Start engine. |
|
| Keep sprayer upright to avoid oil seepage. |
|
|
|
False tripping of WatchDog system. | Operating conditions out of WatchDog | Turn pressure down. Contact Graco Technical |
EMPTY is displayed. Pump does not | parameters. | Assistance to adjust WatchDog parameters. |
run. |
| Operate without WatchDog active (see Opera- |
| Pump output is low, page 6. | tion manual). |
|
|
|
Engine operates, but displacement | Error code displayed. | Reference Pressure Control repair, page 21. |
pump does not operate |
|
|
Pump switch is OFF. | Turn pump switch ON. | |
|
|
|
| Pressure setting too low. | Turn pressure adjusting knob clockwise to |
|
| increase pressure. |
|
|
|
| Fluid filter is dirty. | Clean filter. |
|
|
|
| Tip or tip filter is clogged. | Clean tip or tip filter (see gun manual). |
|
|
|
| Displacement pump piston rod is stuck | Repair pump (see pump manual). |
| due to dried paint. |
|
|
|
|
| Connecting rod is worn or damaged. | Replace connecting rod. Page 15. |
|
|
|
| Drive housing is worn or damaged. | Replace drive housing. Page 16. |
|
|
|
| Electrical power is not energizing clutch | Check wiring connections. Page 21. |
| field. | Reference Digital Display Messages. |
|
| |
|
| Page 14. |
|
| Reference wiring diagram. Page 21. |
|
| With pump switch ON and pressure turned to |
|
| MAXIMUM, use a test light to check for power |
|
| between clutch test points on control board. |
|
| Remove clutch wires from control board and |
|
| measure resistance across clutch coil. At 70° F, |
|
| the resistance must be between 1.2 + 0.2 Ω; if |
|
| not, replace pinion housing. |
|
| Have pressure control checked by authorized |
|
| Graco dealer. |
|
|
|
| Clutch is worn, damaged, or incorrectly | Adjust or replace clutch. Page 19. |
| positioned. |
|
|
|
|
| Pinion assembly is worn or damaged. | Repair or replace pinion assembly. Page 17. |
|
|
|
3A0243A | 5 |