Graco Inc ti14916a, 3A0243A important safety instructions Pressurized Aluminum Parts Hazard

Page 3

Warning

WARNING

PRESSURIZED ALUMINUM PARTS HAZARD

Use of fluids that are incompatible with aluminum in pressurized equipment can cause serious chemi- cal reaction and equipment rupture. Failure to follow this warning can result in death, serious injury, or property damage.

Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids containing such solvents.

Many other fluids may contain chemicals that can react with aluminum. Contact your material sup- plier for compatibility.

SUCTION HAZARD

Powerful suction could cause serious injury.

Never place hands near the pump fluid inlet when pump is operating or pressurized.

CARBON MONOXIDE HAZARD

Exhaust contains poisonous carbon monoxide, which is colorless and odorless. Breathing carbon mon- oxide can cause death.

Do not operate in an enclosed area.

TOXIC FLUID OR FUMES HAZARD

Toxic fluids or fumes can cause serious injury or death if splashed in the eyes or on skin, inhaled, or swallowed.

Read MSDS’s to know the specific hazards of the fluids you are using.

Store hazardous fluid in approved containers, and dispose of it according to applicable guidelines.

BURN HAZARD

Equipment surfaces and fluid that’s heated can become very hot during operation. To avoid severe burns:

Do not touch hot fluid or equipment.

PERSONAL PROTECTIVE EQUIPMENT

You must wear appropriate protective equipment when operating, servicing, or when in the operating area of the equipment to help protect you from serious injury, including eye injury, hearing loss, inhala- tion of toxic fumes, and burns. This equipment includes but is not limited to:

Protective eyewear, and hearing protection.

Respirators, protective clothing, and gloves as recommended by the fluid and solvent manufac- turer.

3A0243A

3

Image 3
Contents Related Manuals Operation 3A0242 Parts 3A0244 Gun Korean patentFire and Explosion Hazard Pressurized Aluminum Parts Hazard Maintenance Pressure Relief ProcedurePremium Sprayers Engine Oil Funnel Problem Cause Solution TroubleshootingThroat packing nut just enough to stop leakage Fluid Pump Runs Constantly Troubleshooting ProcedureControl Board Malfunction Step Control Board Malfunction StepsConvertible Electric Motor Will Not Run Step Convertible Electric Motor Will Not Run StepsSee step Is there over 10-20 AC volts? Beep Two blinks is the same as E=02 Digital Display MessagesRelieve pressure Bearing Housing and Connecting RodInstallation RemovalDrive Housing Pinion Assembly/Clutch Armature/Clamp Pinion AssemblyClutch Armature Installation Clutch Housing Engine Pressure Control Pump ON/OFF SwitchPressure Adjust Potentiometer Control BoardPressure Control Transducer Do Pressure Relief, Displacement PumpPlace u-bolt on pump door protrusion Tighten latch and rotate latch lock into locked posi- tion Hose Reel Grease shaft Install E-clip Pivot Replacement Technical Data Dimensions 3A0243A For Graco Canada Customers Graco Standard Warranty