Graco Inc 3A0243A, ti14916a important safety instructions Hose Reel

Page 26

Hose Reel

Hose Reel

Removal

4. Remove swivel cap.

Be sure to keep your head clear of hose reel while winding up hose.

1. Remove hose fitting from swivel cap and completely remove hose.

5. Remove snap ring.

ti15023a

2. Remove cap from swivel.

6. Remove hose reel.

ti13675a

ti13543a

ti13542a

3. Remove E-clip from swivel shaft.

ti15024a

ti13538a

26

3A0243A

Image 26

Contents Korean patent Related Manuals Operation 3A0242 Parts 3A0244 GunFire and Explosion Hazard Pressurized Aluminum Parts Hazard Premium Sprayers Engine Oil Funnel MaintenancePressure Relief Procedure Troubleshooting Problem Cause SolutionThroat packing nut just enough to stop leakage Troubleshooting Procedure Fluid Pump Runs ConstantlyControl Board Malfunction Control Board Malfunction Steps StepConvertible Electric Motor Will Not Run Convertible Electric Motor Will Not Run Steps StepSee step Is there over 10-20 AC volts? Beep Digital Display Messages Two blinks is the same as E=02Removal Bearing Housing and Connecting RodInstallation Relieve pressureDrive Housing Clutch Armature Pinion Assembly/Clutch Armature/ClampPinion Assembly Installation Clutch Housing Engine Pump ON/OFF Switch Pressure ControlPressure Control Transducer Pressure Adjust PotentiometerControl Board Displacement Pump Do Pressure Relief,Place u-bolt on pump door protrusion Tighten latch and rotate latch lock into locked posi- tion Hose Reel Grease shaft Install E-clip Pivot Replacement Technical Data Dimensions 3A0243A Graco Standard Warranty For Graco Canada Customers