Pinion Assembly/Clutch Armature/Clamp
Pinion Assembly/Clutch Armature/Clamp
Pinion Assembly/Clutch Armature Removal
Pinion Assembly
If pinion assembly (29) is not removed from clutch hous- ing (19), do 1. through 3. Otherwise, start at 4.
6.Remove retaining ring (29b).
7.Turn pinion assembly over and tap pinion shaft (29a) out with plastic mallet.
27
29b 
1.Remove drive housing; page 16.
2.Disconnect clutch cable connectors from inside of pressure control.
a.Remove two screws (71) and swing down cover (130a).
b.Disconnect engine leads from board to engine.
c.Remove strain reliefs 130r and 123.
3.Remove four screws (36) and pinion assembly (29).
36
37
1929
36
37
ti5480a
4.Place pinion assembly (29) on bench with rotor side up.
5.Remove four screws (28) and lock washers (24). Install two screws in threaded holes (E) in rotor. Alternately tighten screws until rotor comes off.
28 
29
24
E 
E
29a
29d
ti5482a
Clutch Armature
8.Use an impact wrench or wedge something between clutch armature (25) and clutch housing to hold engine shaft during removal.
9.Remove four screws (23) and lock washers (24).
10.Remove armature.
TIA
ti5481a
ti5987b
3A0243A | 17 |