Graco Inc ti14916a, 3A0243A important safety instructions Grease shaft Install E-clip

Page 27

Hose Reel

Installation

1. Grease shaft.

5. Install E-clip.

ti13537a

2.Make sure two washers and wave spring are on hub before hose reel is installed.

ti13545a

3.Install hose reel onto frame. Place C-clamp on reel and frame to allow snap ring to fit into place. Install snap ring.

ti13536a

4. Install swivel cap.

ti13543a

ti13538a

6.Install hose to hose cap. Make sure to route hose through side arm of hose reel.

ti15023a

7.Wrap up hose. Make sure hose is routed through hose guide.

ti13504a

3A0243A

27

Image 27

Contents Related Manuals Operation 3A0242 Parts 3A0244 Gun Korean patentFire and Explosion Hazard Pressurized Aluminum Parts Hazard Maintenance Pressure Relief ProcedurePremium Sprayers Engine Oil Funnel Problem Cause Solution TroubleshootingThroat packing nut just enough to stop leakage Fluid Pump Runs Constantly Troubleshooting ProcedureControl Board Malfunction Step Control Board Malfunction StepsConvertible Electric Motor Will Not Run Step Convertible Electric Motor Will Not Run StepsSee step Is there over 10-20 AC volts? Beep Two blinks is the same as E=02 Digital Display MessagesRelieve pressure Bearing Housing and Connecting RodInstallation RemovalDrive Housing Pinion Assembly/Clutch Armature/Clamp Pinion AssemblyClutch Armature Installation Clutch Housing Engine Pressure Control Pump ON/OFF SwitchPressure Adjust Potentiometer Control BoardPressure Control Transducer Do Pressure Relief, Displacement PumpPlace u-bolt on pump door protrusion Tighten latch and rotate latch lock into locked posi- tion Hose Reel Grease shaft Install E-clip Pivot Replacement Technical Data Dimensions 3A0243A For Graco Canada Customers Graco Standard Warranty