
Receiver | ® |
|
Changing the Depth Measurement Units (English vs. Metric)
The DigiTrak Receiver is capable of displaying depth in either inches (English) or centimeters (metric). The depth measurement units can only be changed during the
To change the measurement units:
Instead of clicking the trigger to initiate
Older receivers that have not been upgraded require a different method for changing the depth measure- ment units. Contact DCI Customer Service
Battery Status Display for Receiver and Transmitter
The receiver will prompt the operator when the recharge- able NiCad battery is low (approximately 1 hour of usage left) by displaying BAT in the bottom window.
The receiver’s battery voltage is displayed in the bottom window during
The percentage of remaining battery life in the receiver will display in the top right window after releasing a
If you observe the BAT symbol in the top left window, then the transmitter batteries are low, and the transmitter bat- tery status should be checked. To view the percentage of battery life remaining in the transmitter’s battery, hold and then release the trigger. The status is displayed in the top left window for 2 seconds, after which the pitch display will resume. This information will display only as 100, 90, 75, 50, 25, 10, 5, or 0. The receiver’s NiCad battery percent remaining also displays during this
NOTE: Mark III Receivers do not display the transmitter battery and temperature information until 4 minutes after
507I
I55
Receiver Battery Status,
Voltage Remaining
BAT 90 75 
I I9
Transmitter (left) and Receiver (right)
Battery Life Remaining
in Percentages
10 | DigiTrak® Mark III Operator’s Manual |