® | Transmitter |
|
The temp dot should be white if the transmitter has not been exposed to excessive heat. If the temp dot is silver or gray, it indicates the transmitter has been exposed to heat but not in excess of the speci- fications. A black temp dot indicates the transmitter has been exposed to temperatures in excess of 104°C (220°F). The transmitter will shut off at about 80°C.
If the transmitter overheats, it may appear to operate normally; however, exposure to excessive tempera- tures greatly increases the likelihood of inaccurate information and will contribute to premature failure of the transmitter. The warranty does not apply to any transmitter that has been overheated or to any transmitter where the temp dot has been removed. Avoid overheating by practicing proper drilling techniques. Abrasive soils, clogged ports, inadequate mud flow, and poorly mixed mud can contribute significantly to the risk of an overheated transmitter.
The transmitter temperature warnings are listed in the following table. These warnings apply for firmware versions greater than 3.76. Drilling should be suspended when temperatures reach 35°C to permit cooling.
Transmitter Temperature Warnings
Temperature Range
Warning Signal
14°C and below | No audio or visual warnings. |
15°C to 35°C | One double tone with every 4°C increase in temperature. |
|
|
36°C to 45°C | Two double tones with every 4°C increase in temperature. |
45°C to 60°C | Three double tones with every 4°C increase in temperature. |
|
|
60°C and above | Audible error tones (two long tones) and the bottom window will flash; |
| 1999 may appear when the transmitter shuts down at about 80°C. |
Sleep Mode (Automatic Shutoff)
The transmitter will shut down (go into “sleep” mode) to conserve battery power if it is stationary for 15 minutes. The transmitter sleep mode can be recognized on the receiver as “1999” in the bottom window (no signal). To “wake up” the transmitter, simply rotate the drill string. For more information on 1999 in the bottom window, see the Operational Tests Section, particularly “Transmitter Tests,” and the Trouble- shooting Section.
Transmitters manufactured prior to January 1997 have what is called “12 o’clock shutoff.” This means that when the transmitter is in the 12 o’clock position, the transmitter will shut off for 10 seconds and 1999 will be displayed in the bottom window of the receiver.
Verifying Proper Fit of Transmitter in Housing
Before installing a transmitter into a housing, read the information given below about how the transmitter should fit into the housing. You may then proceed to the installation instructions that follow.
How Transmitter Should Fit in Housing
The transmitter must fit snugly into the housing. The transmitter has an index slot in the front end cap that fits onto the
DigiTrak® Mark III Operator’s Manual | 21 |