
® | Receiver |
|
For receivers that have
Any time the trigger is clicked (pushed in and released in less than ½ second), the receiver will initiate an ultrasonic measurement, which is also referred to as the
Changing the Receiver’s Channel Setting
If using a remote display unit, the receiver and remote display unit must each be set to the same channel. Changing the receiver’s channel selection can only be done at
To change the channel:
At the end of the
NOTE: A zero (0) remote channel setting indicates that the receiver’s telemetry signal is shut off and no signal is being sent to the remote display unit. “Dashes” will appear across the three display windows on the remote display to indicate no signal is being received. Setting the receiver to channel 0 can be done to conserve the receiver’s battery (see Remote Display Section).
The DigiTrak System uses
DigiTrak® Mark III Operator’s Manual | 9 |