Dell 7x0N manual See Also

-xDetach IP from an incoming SVC or PVC. IP traffic will no longer be accepted on the specified VPI and VCI.

-fDelete all dynamic address mappings from the ATM ARP table and close all Switched Virtual Circuits (SVCs) to all hosts in the table.

NOTES

The allowed values for vpi, vci, aal, and peak will depend on the capabilities of the ATM adapter used by the given interface. In addition, certain adapters may only support discrete peak cell rates. If so, the rate will be set to the closest sup- ported rate, which is less than the specified rate.

encapsulation must be one of null (no encapsulation, the default), llc_routed (IEEE LLC encapsulation for routed PDUs), or llc_bridged_8023 (IEEE LLC encap- sulation for Ethernet/802.3 bridged PDUs). If encapsulation is specified as llc_bridged_8023, the following argument must be the 6-byte colon separated destination MAC address. decapsulation must be either null (no decapsulation, the default) or llc (IEEE LLC decapsulation).

CLUSTER CONSIDERATIONS

In takeover mode, the FORE/IP SPANS interface names are those on the live filer, and in partner mode interface names are those on the failed filer.

In takeover mode, the atmarp command only affects the arp entries of the live filer, and in partner mode the atmarp command only affects the arp entries of the failed filer.

SEE ALSO

na_arp(1),

32 Dell PowerVault 7x0N Systems — Connecting to ATM and FDDI Networks