Hobart Welding Products OM-944 196 639G, 175 manual Changing Drive Roll Or Wire Inlet Guide

6-4. Changing Drive Roll Or Wire Inlet Guide

1

1Inlet Wire Guide Securing Screw

2Inlet Wire Guide

Loosen screw. Slide tip as close to drive rolls as possible without touching. Tighten screw.

3 Drive Roll

2

Tools Needed:

3

4

The drive roll consists of two differ- ent sized grooves. The stamped markings on the end surface of the drive roll refers to the groove on the opposite side of the drive roll. The groove closest to the motor shaft is the proper groove to thread (see Section 4-10).

4 Retaining Pin

To secure drive roll, locate open slot and push drive roll completely over retaining pin, then rotate drive roll (1/4 turn) to closed slot.

.030/.035 Groove

Stamped .024

.024 Groove

Stamped .030/.035

Ref. 802 444-B

6-5. Replacing Gun Contact Tip

Y Turn Off power before replacing contact tip.

1 Nozzle

2 Contact Tip

Cut off welding wire at contact tip.

Remove nozzle.

Remove contact tip and install new contact tip. Reinstall nozzle.

2

1

Tools Needed:

Ref. 802 399-A

Return To Table Of Contents OM-944 Page 25