ENGLISH
Connecting an antenna
Connecting an FM/AM antenna
•Connect the FM antenna or AM loop antenna supplied with the unit to enjoy listening to radio broadcasts.
•After connecting the antenna and receiving a broadcast signal (vpage 27 “Listening to FM/AM broadcasts”), fix the antenna with tape in a position where the noise level becomes minimal.
Direction of broadcasting station
|
|
|
| AM loop antenna | |
FM outdoor | q | w | e | (supplied) |
|
antenna |
|
| |||
|
|
|
|
| |
75 Ω Coaxial |
|
|
|
|
|
cable |
|
|
|
|
|
|
|
|
| Black | White |
FM indoor
antenna
(supplied)
nnUsing the AM loop antenna
Suspending on a wall
| AM outdoor | Suspend directly on a wall without assembling. |
Ground |
| |
antenna |
|
Nail, tack, etc.
Connecting a SIRIUS connector
•This unit is a SIRIUS Satellite Radio Ready® receiver. You can receive SIRIUS® Satellite Radio by connecting to the SiriusConnect Home Tuner and subscribing to the SIRIUS service.
•Plug the SIRIUS connector on the SIRIUS service.
•Position the Home Tuner antenna near a
For details, see “Listening to SIRIUS satellite radio” (vpage 25). When making connections, also refer to the operating instructions of the SiriusConnect Home Tuner.
SiriusConnect Home Tuner
When connecting digital audio
nnAM loop antenna assembly
Standing alone
1 Put the stand section through the bottom of the loop antenna from the rear and bend it forward.
2 Insert the projecting part into the square hole in the stand.
Stand
Square
hole
Loop 
Projecting
antenna
part
Use the procedure shown left to assemble.
NOTE
•Do not connect two FM antennas simultaneously.
•Even if an external AM antenna is used, do not disconnect the AM loop antenna.
•Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.
•If the signal has noise interference, connect the ground terminal (GND) to reduce noise.
•If you are unable to receive a good broadcast signal, we recommend installing an outdoor antenna. For details, inquire at the retail store where you purchased the unit.
in Set as Necessary
When connecting digital of the SiriusConnect Home Tuner, perform the setting “Digital”.
“Input Assign” (vpage 48)
20
