Marantz SR5005 manual Operating learn mode, NnLearning procedure

LEARN indicator lights.

Press ENTER to continue erasing.

• The SEND indicator blinks twice and the mode returns to LEARN mode.

• To cancel the erasing operation, do not press ENTER, and simply press any

other button.

To return the normal mode, press SET.

Repeat steps 3 to 6 to learn other input sources.

To return the normal mode, press SET.

1 Press and hold down SET and SOURCE SEL until the LEARN indicator blinks.

2 Press and hold down D.MODE and press the learned input source select buttons to be erased twice.

Erasing the code by SOURCE

4

nnErasing programmed codes

Codes can be erased in three ways: by buttons, sources, and by all memory contents.

Erasing the code by buttons

1 Press and hold down SET and SOURCE SEL until the LEARN indicator blinks.

2 Press input source select buttons to select the input source you

want to delete.

3 Press and hold down D.MODE

and press the learned button to be erased twice. SEND indicator blinks twice and the mode returns to LEARN mode.

ENGLISH

Operating learn mode

This remote control unit is capable of learning and storing codes used by other remote controls that you already own.

For codes which are not learned, the remote control unit will transmit either the Marantz preset codes from the initial settings, or remote codes from another manufacturer’s AV equipment which is set by the customer.

The receiver sensor for the remote control unit signals is located at the top of the remote control unit.

This remote control unit is capable of learning around 160 codes.

NOTE

The learning procedure does not operate correctly if the batteries have become worn.

nnLearning procedure

1 Place the Marantz remote control and remote control from the other device approximately 5 cm apart, with the remote control signal transmission sections facing each other.

5 cm

4 Select the button to be learned. LEARN indicator lights up.

NOTE

•The learning function is unavailable for all SOURCE and D.MODE in any mode.

•The learning function is unavailable for all buttons in TUNER mode and AMP mode.

5 Press and hold the button of the original remote control unit to be learned until the SEND indicator blinks twice.

NOTE

•If the SEND indicator blinks once, repeat this step.

•If the LEARN indicator flashes when the SEND indicator is lit, then the button cannot be learned.

•When the memory of the remote control unit is full, the LEARN and SEND indicators blink once. If you want to learn the code, you need to erase a different learned button.

6 Repeat steps 4 and 5 to learn other buttons for the same input source.

7

8 When programming of the remote control unit is completed, press SET.

The LEARN display disappears, and the remote control unit exits learn mode.

2 Press and hold down SET and SOURCE SEL until the LEARN indicator blinks.

3 Press input source select buttons to select the input source.

NOTE

•When the SEND indicator blinks once again, the transmitting code is unavailable for remote control unit, or the transmitting signal has been interrupted by noise.

•If no buttons are pressed for approximately 1 minutes while in the LEARN mode, the remote control unit automatically exits from the LEARN mode.

3

4

66