Marantz SR5005 manual Set up speakers, Set up Amp Assign, Set up F. Height, Set up Front.Sp

SVENSKA	NEDERLANDS	ESPAÑOL	ITALIANO	FRANÇAIS	DEUTSCH	ENGLISH
Set up speakers		around items indicate the settings.

This section provides the setup methods of speaker systems other than the 7.1-channel system (with surround back speakers).

For the setup methods of the 7.1-channel system with surround back speakers, see “Set up speakers (Audyssey® Auto Setup)” (vpage 6) of “Simple version”.

First install and connect the speakers to this unit.

Simple version

1	Set up
	the remote control unit

nn Set up the operation mode

Press AMP to set the remote control unit to amplifier operation mode.

Press AMP

2 Connect the setup microphone.

When the setup microphone is connected, the following screen is displayed.

3-1.Audyssey Auto Setup MultEQ Please place microphone

at ear height at

main listening position.

F.Height : Measure

Front Sp. : A

Amp Assign: Normal

Start

Cancel [ENT]:Select [RTN]:Back

3 Set up “Amp Assign”

Use ui to select “Amp Assign”.

3-1.Audyssey Auto Setup MultEQ

Please place microphone at ear height at

main listening position.

F.Height : Measure

Front Sp. : A

Amp Assign: Normal

Start

Cancel

[RTN]:Back

4 Use o p to select the configuration of the connected speakers.

			Set when using 7.1-channel
	Normal
			(Front/Center/Surround/Surround
			Back or Front height/Subwoofer)
			speakers.
			Set for connecting the speakers
	ZONE2
			for ZONE2 to the SURR. BACK/
			AMP ASSIGN terminals.
			Set for connecting a tweeter of
	SPKR-C
			a front speaker to the SURR.
			BACK/AMP ASSIGN terminals
			and a woofer of the front speaker
			to the FRONT A terminals.
5		Set up “F. Height”
	Press	u to select “F. Height”.
			Set to measure the front height
	Measure
			speakers.
			Set not to measure the front
	Skip
			height speakers.

6 Set up “Front.Sp.”

Use ui to select “Front Sp.” and then press o p to select a speaker.

ASelect this to use front speaker A.

BSelect this to use front speaker B.

A+B Select this to use front speakers A and B simultaneously.

NOTE

If “Mesure” is selected in step 5, select “A”. If “B” is selected, the “F.Height” measurement cannot be performed.

7 Proceed to page 8

“Preparation ” step 5.

NOTE

After performing Audyssey Auto Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey Auto Setup again.

Basic version

Advanced version

Information

Remote control operation	Move the cursor	Confirm the setting	Return to previous menu	37
buttons	(Up/Down/Left/Right)