Marantz SR5005 nnProgramming with the 4-digitcode, nnScanning the code table, nnChecking the code

ENGLISH

nnProgramming with the 4-digit code

1 Press and hold down the input source select buttons for the appliance to control, and press SET until the SEND indicator blinks twice.

The back light flashes.

2 Press the 4-digit code for the appliance using the numeric buttons (code table at the end of this book).

When the procedure is successful, the

SEND indicator blinks twice.

NOTE

If the indicator did not blink twice, then repeat steps 1 and 2 and try entering the same code again.

nnScanning the code table

1 Switch on the appliance to control.

2 Press and hold down the input source select buttons for the appliance to control, and press SET until the SEND indicator blinks twice.

The back light flashes.

3 Aim the remote control at the appliance and slowly alternate between pressing INPUT d and SOURCE ON/OFF for the appliance.

4 Stopoff. when the appliance turns

5 Presscode. ENTER once to lock in the

nnChecking the code

1 Press and hold down the input source select buttons for appliance to control, and press SET until the SEND indicator blinks twice and back light flashes.

The back light flashes.

2 Press SEARCH/INFO.

The SEND indicator blinks twice.

3 To view the code for first digit, press 1 once.

Count the number of times the SEND indicator blinks (e.g. 3 blinks = 3) and write down the number.

4 Then press 2 to check the second digit of the code. Now press 3 and 4 to check the third and fourth digits of the code.

NOTE

If a code digit is “0”, the SEND indicator does not blink.

Registering preset codes

nnResetting the code

The devices shown below are registered for each input source button as default. Settings can be changed according to the devices to be used.

Press and hold down the
1 input source select buttons for
appliance to control and press
SET until the SEND indicator
blinks twice.
The back light flashes.
2 code.Press the codes below to reset the
The indicator will blink twice.
Input source select	Category	Preset code
buttons
	Blu-ray Disc player	5000
	DVD player	2000
	Television	1000
	Satellite set top box	4000
	CD player	3000

NOTE

After this procedure, the selected source reset to its initial code.

64