SVENSKA | NEDERLANDS | ESPAÑOL | ITALIANO | FRANÇAIS | DEUTSCH | ENGLISH |
Set up speakers (Audyssey® Auto Setup)
About setup microphone placement
• Measurements are performed by placing the setup microphone |
successively at multiple positions throughout the entire listening |
area, as shown in GExample qH. For best results, we recommend |
you measure in six positions, as shown in the illustration (up to six |
positions). |
1 | Set up the microphone |
|
Mount the setup microphone on a tripod or stand and place it in the main listening position.
When placing the setup microphone, adjust the height of the sound receptor to the level of the listener’s ear.
3 | Set up the remote control unit |
nn Set up the operation mode
Press AMP to set the remote control unit to amplifier operation mode.
Simple version
• Even if the listening environment is small as shown in GExample wH, |
measuring at multiple points throughout the listening environment |
results in more effective correction. |
| GExample qH |
|
| GExample wH | ||
| FL SW C | FR |
|
| FL SW C | FR |
( | : Measuring positions) |
| ( | : Measuring positions) | ||
SL | *M | SR | SL |
| *M | SR |
|
|
|
|
| ||
| SBL | SBR |
|
| SBL | SBR |
Sound receptor
NOTE
Setup microphone
Press AMP
Basic version
Advanced
FL | Front speaker (L) | SL | Surround speaker (L) |
FR | Front speaker (R) | SR | Surround speaker (R) |
C | Center speaker | SBL Surround back speaker (L) | |
SW Subwoofer | SBR Surround back speaker (R) |
About the main listening position (*M)
The main listening position is the position where listeners would normally sit or where one would normally sit alone within the listening environment. Before starting Audyssey Auto Setup, place the setup microphone in the main listening position. Audyssey MultEQ® uses the measurements from this position to calculate speaker distance, level, polarity, and the optimum crossover value for the subwoofer.
•Do not hold the setup microphone in your hand during measurements.
•Avoid placing the setup microphone close to a seat back or wall as
sound reflections | may give inaccurate results. |
|
|
2 | Set up the subwoofer |
If using a subwoofer capable of the following adjustments, set up the subwoofer as shown below.
nn When using a subwoofer with a direct mode
Set the direct mode to “On” and disable the volume adjustment and crossover frequency setting.
nn When using a subwoofer without a direct mode
Make the following settings:
•Volume : “12 o’clock position”
•Crossover frequency : “Maximum/Highest Frequency”
•Low pass filter : “Off”
•Standby mode : “Off”
version
Information
The “Simple version” section provides the speaker installation, connection, and setup methods for the | 7 |
For the installing, connecting, and setup methods of speakers other than the |
|
|
|