SVENSKA | NEDERLANDS | ESPAÑOL | ITALIANO | FRANÇAIS | DEUTSCH | ENGLISH |
Set up speakers (Audyssey® Auto Setup)
Step 3 | Step 4 |
Calculating | Check |
|
|
Step 5
Store
Finish
Simple version
10On the | Step 2 | screen, use | ui |
|
|
to select “Calculate”, and then press
ENTER.
Measuring results are analyzed, and the frequency response of each speaker in the listening room is determined.
Step3:Calculating
MultEQ
Calculating
Please wait...
•Analysis takes several minutes to complete. The time required for this analysis depends on the number of speakers connected.
The more connected speakers there are, the longer it takes to perform analysis.
11Use ui to select the item you want to check, and then press ENTER.
Step4:Check
MultEQ Please check the results of the measured item.
Speaker Config.Check Distance Check Channel Level Check
Crossover Freq.Check Next
[ENT]:Select
•Subwoofers may measure a greater reported distance than the actual distance due to added electrical delay common in subwoofers.
•If you want to check another item, press
RETURN.
12Use ui to select “Next” and then press ENTER.
NOTE
•If the result differs from the actual connection status, or if “Caution!” is displayed, see “Error messages” (vpage 10). Then carry out Audyssey Auto Setup again.
•If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker connections and repeat the measurement process from the beginning.
•If you change speaker positions or orientation, perform Audyssey Auto Setup again to find the optimal equalizer settings.
13Use ui to select “Store” and then press ENTER.
Save the measurement results.
Step5:Store
MultEQ
Please select “Store” to store measurement values.
Store
Cancel
[ENT]:Store
Step5:Store
MultEQ
Storing
Please wait...
•Saving the results requires about 10 seconds.
•If you do not want to save the measurement results, use ui to select “Cancel”, then select “Yes” using o p. All the measured Audyssey Auto Setup data will be erased.
NOTE
During saving of measurement results, be sure not to turn off the power.
14Unplug the setup microphone from the unit’s SETUP MIC jack.
15Set Dynamic Volume®.
Finish
MultEQ
Storing complete. Auto Setup is now
finished.
Turn on Dynamic Volume?
Yes:No
[]:Select [ENT]:Exit
•For details of Dynamic Volume settings, see page 54.
nn When turning Dynamic Volume on
•Use o to select “Yes”, and then press ENTER. The unit automatically enters “Evening” mode.
nn When turning Dynamic Volume off
• Use p to select “No”, and then press ENTER.
NOTE
After performing Audyssey Auto Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey Auto Setup again.
Basic version
Advanced version
Information
Remote control operation | Move the cursor | Confirm the setting | Return to previous menu | 9 |
buttons | (Up/Down/Left/Right) |
| ||
|
|
|