ENGLISH
Other settings
Remote control settings
•When you connect a remote control receiver unit (purchased separately) to the REMOTE CONTROL IN terminal of this unit, use the following procedure to disable the remote sensor function of this unit.
•The remote sensor function of remote control signals is enabled by default.
ENTER | o p RETURN ZONE2 ON/OFF |
Switching the on-screen display output mode
Set whether the menu is operated by the monitor connected to the VIDEO OUT terminal or the monitor connected to the COMPONENT VIDEO MONITOR OUT terminal.
• The factory setting is “Comp”.
RETURN PURE DIRECT
nnDisabling the sensor function of the remote control
1 To enable the remote signal sensor function, press and hold ZONE2 ON/OFF and RETURN for 3 seconds.
“IR:< ENABLE >” is displayed.
2 Press o p to select “DISABLE”.
3 Press ENTER.
The sensor function of the remote control signal of this unit is disabled.
NOTE
If a remote control receiver unit (purchased separately) is not connected, do not perform this setting. If you do, you will not be able to operate this unit using the remote control.
nnEnabling the remote sensor function
1 To disable the remote signal sensor function, press and hold ZONE2 ON/OFF and RETURN for 3 seconds.
“IR:< DISABLE >” is displayed.
2 Press o p to select “ENABLE”.
3 Press ENTER.
The sensor function of the remote control signal of this unit is enabled.
ENTER o p
1 Press and hold RETURN and PURE DIRECT for 3 seconds.
Corresponding to the video signal format settings,
“OSD Out: 0 Comp 1” or “OSD Out: 0 Video 1” is shown in the display.
2 Press o p to change the settings according to the connection method.
Comp | Set when the COMPONENT VIDEO MONITOR OUT |
| connector is connected to a TV. |
| Set when the VIDEO OUT connector is connected |
Video | |
| to a TV. |
3 Press ENTER to enter the setting.
NOTE
When operating the
62
