Weber 5000 owner manual Install tank panel assembly, Install right end panel

Page 17

Step 14

Install tank panel assembly

You will need: tank panel assembly.

Slide the side burner back. Insert the tabs into the slots in the frame brace at the wheel legs. (Make sure the side burner hose is to the front of the barbecue.) Figure 17 (a). Slide up until the notch at the bottom of the tank panel fits over the cross brace. Figure 17 (b).

Slot in frame brace

(a)

Frame brace

Tabs on tank panel

Side burner

(b)

hose

 

Figure 17

Cross brace

Step 15

Install right end panel

You will need: right end panel (Number 3), 1/4-20 x 1 1/2 inch bolt, 1/4-20 hex nut, two nylon washers and a 7/16 inch wrench.

Set the right end panel in place with the flange at the top facing away from the barbecue, and the bottom flange under the frame brace. Figure 18.

Make sure the gas supply hose is on the outside of the panel. Put washer on bolt and insert bolt through both panels and frame brace. Add washer and hex nut and tighten. Figure 18.

Hose and regulator

Side burner hose

Figure 18

17

Image 17
Contents Genesis 5000 Series LP GAS Units only Warranty Patents and Trademarks Contents General Instructions For Installation in CanadaStorage Operating areaStep AssemblyCheck package contents Page Page Check contents of hardware packs Assemble frame Assemble wheelsComplete frame assembly Continue frame assemblyInsert casters Check the frame assemblyInstall left end panel Install side burner locks Install the three back panelsAdd cooking box Install manifold bracket Install side burnerInstall right end panel Install tank panel assemblyAdd fuel scale Install bottom accessory traysInstall igniter Check that all burner valves are off Install left hand swing tableInstall right hand swing table Hinge rod View from rear of barbecue Fill LP tank Set LP fuel scaleConnect LP tank Check for gas leaks Insert Flavorizer Bars Steam-N-Chips Smoker Install the bottom tray Install cooking gratesInstall the lid Secure side burner Install glass doorsComplete accessory installation To Extinguish LightingManual Lighting Lighting the side burner Side burner will only operate when the Front burner is litCooking Periodic CleaningStorage and/or Nonuse Storage and/or NonuseTo use the Steam-N-Chips Smoker Using the Steam-N-Chips SmokerRemoval of the LP tank Refilling the LP tankEngaged Liquid Propane LP Tanks Safe handling tips for LP GasInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Cleaning Procedure General MaintenanceWeber Spider Stopper Guards Main Burner Flame PatternView from behind cooking box Wing nuts Crossover Ignition System Operations FlameCheck Safety System Burner does not light, or flame is low in High position When burner is on HIGH. Flames do not runBurner flame pattern is erratic. Flame is low Resembles paint peelingSide Burner Maintenance Side Burner TroubleshootingProblem Check Cure Side burner does not light Flame is low in High positionPage 19-20 22-24 Parts List Final Word Thanks
Related manuals
Manual 44 pages 20.87 Kb