Weber 5000 owner manual Add fuel scale, Install bottom accessory trays, Install igniter

Step 16

Add fuel scale

You will need: fuel scale assembly, two 1/4-20 wing nuts and two nylon washers.

Insert indicator rod of fuel scale through the elongated hole in the right end panel. Figure 19 (a).

Slip the bolts on the back of the fuel scale assembly through the two small holes in the right end panel and tank panel. Add washers, then wing nuts and tighten. Figure 19 (b).

(b)	(a)
	E
	E
	F
	F
View from front left	View from front right

Figure 19

Step 17

Install bottom accessory trays

You will need: two accessory trays

Set the two accessory trays between the two frame connectors. Figure 20.

Figure 20

Step 18

Install igniter

Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.

The igniter lock nut is on the igniter.

Insert the top of the igniter up through the large part of the keyhole in the frame brace. Figure 21 (b). Loosen the igniter lock nut and slide the igniter into the small part of the keyhole. Figure 21 (c). Tighten the igniter lock nut. Figure 21.

Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.

(a)

Frame brace

(b)

Igniter lock nut

Keyhole in frame brace

Figure 21

(c)

Frame brace

Small part of keyhole in frame brace

18