Weber 5000 owner manual Hinge rod View from rear of barbecue

Page 21

Insert one end of the hinge rod into the hole in the frame. Figure 28 (a).

Insert the other end into the hole in the swing table end bracket. Figure 28 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube. Push the bracket into the frame. Check to see that the lower tab of the bracket is hooked in the slot in the frame. Figure 28 (c).

To fully seat the bracket, you may have to tap it lightly with a hammer.

WARNING: If swing table end bracket is in any way cracked or damaged, do not use swing table. Call our Customer Service Center to order a new part.

WARNING: The load limit for the swing table is 30 pounds.

(a)

(b)

Hinge rod

View from rear of barbecue

(c)

Position slide bar assembly on the outside of the wheel frame. Put a nylon washer on each 1 3/4 inch screw, insert screws through frame and slide bar assembly and add nylon washers and hex nuts. Tighten nuts using a screwdriver and pliers. Figure 29.

Notch

F

Slide bar

 

F

View from front of barbecue

Wheel frame

Figure 29

To lower table: Pull support rod up to disengage slide lock and lower table. To raise table, lift table up and engage slide in locked position. Figure 30.

Support rod

Figure 28

Slide

Slot in frame (view from below)

Unlocked position

Locked position

Figure 30

21

Image 21
Contents Genesis 5000 Series LP GAS Units only Warranty Patents and Trademarks Contents General Instructions For Installation in CanadaStorage Operating areaAssembly Check package contentsStep Page Page Check contents of hardware packs Assemble frame Assemble wheelsComplete frame assembly Continue frame assemblyCheck the frame assembly Install left end panelInsert casters Install side burner locks Install the three back panelsAdd cooking box Install manifold bracket Install side burnerInstall right end panel Install tank panel assemblyInstall bottom accessory trays Install igniterAdd fuel scale Check that all burner valves are off Install left hand swing tableInstall right hand swing table Hinge rod View from rear of barbecue Fill LP tank Set LP fuel scaleConnect LP tank Check for gas leaks Insert Flavorizer Bars Steam-N-Chips Smoker Install the bottom tray Install cooking gratesInstall the lid Secure side burner Install glass doorsComplete accessory installation To Extinguish LightingManual Lighting Lighting the side burner Side burner will only operate when the Front burner is litCooking Periodic CleaningStorage and/or Nonuse Storage and/or NonuseTo use the Steam-N-Chips Smoker Using the Steam-N-Chips SmokerRemoval of the LP tank Refilling the LP tankEngaged Liquid Propane LP Tanks Safe handling tips for LP GasInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Cleaning Procedure General MaintenanceWeber Spider Stopper Guards Main Burner Flame PatternView from behind cooking box Wing nuts Crossover Ignition System Operations FlameCheck Safety System Burner does not light, or flame is low in High position When burner is on HIGH. Flames do not runBurner flame pattern is erratic. Flame is low Resembles paint peelingSide Burner Maintenance Side Burner TroubleshootingProblem Check Cure Side burner does not light Flame is low in High positionPage 19-20 22-24 Parts List Final Word Thanks
Related manuals
Manual 44 pages 20.87 Kb