Weber 5000 owner manual FlameCheck Safety System

Page 42

FlameCheck Safety System

The correct positioning of the thermocouple probe is shown in Figure 23. The tip of the probe is positioned in the flame. The probe senses the heat from the Front burner, and activates the FlameCheck valve. The valve allows the gas to flow into the Front burner. If the Front burner should go out for any reason, the thermocouple probe will cool off, thereby closing the FlameCheck valve, which stops the gas flow to the burners.

If the FlameCheck Safety System should fail to operate, contact Weber-Stephen Customer Service.

Center line

Thermocouple nuts

1/8 inch

Ignition holes

Wall of cooking box

Figure 23

42

Image 42

Contents Genesis 5000 Series LP GAS Units only Warranty Patents and Trademarks Contents Storage For Installation in CanadaGeneral Instructions Operating areaAssembly Check package contentsStep Page Page Check contents of hardware packs Assemble wheels Assemble frameContinue frame assembly Complete frame assemblyCheck the frame assembly Install left end panelInsert casters Install the three back panels Install side burner locksAdd cooking box Install side burner Install manifold bracketInstall tank panel assembly Install right end panelInstall bottom accessory trays Install igniterAdd fuel scale Install left hand swing table Check that all burner valves are offInstall right hand swing table Hinge rod View from rear of barbecue Set LP fuel scale Fill LP tankConnect LP tank Check for gas leaks Insert Flavorizer Bars Steam-N-Chips Smoker Install cooking grates Install the bottom trayInstall the lid Install glass doors Secure side burnerComplete accessory installation Lighting To ExtinguishManual Lighting Side burner will only operate when the Front burner is lit Lighting the side burnerStorage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseUsing the Steam-N-Chips Smoker To use the Steam-N-Chips SmokerRefilling the LP tank Removal of the LP tankEngaged Safe handling tips for LP Gas Liquid Propane LP TanksAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsWeber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure Main Burner Flame PatternView from behind cooking box Wing nuts Crossover Ignition System Operations FlameCheck Safety System Burner flame pattern is erratic. Flame is low When burner is on HIGH. Flames do not runBurner does not light, or flame is low in High position Resembles paint peelingProblem Check Cure Side burner does not light Side Burner TroubleshootingSide Burner Maintenance Flame is low in High positionPage 19-20 22-24 Parts List Final Word Thanks

Related manuals

Manual 44 pages 20.87 Kb