Weber 5000 owner manual Install right hand swing table

Page 20

Position slide bar assembly on the outside of the caster frame. Put a nylon washer on each 1 3/4 inch screw, insert screws through frame and slide bar assembly and add nylon washers and hex nuts. Tighten nuts using a screwdriver and pliers. Figure 25.

Notch to the front

Slide bar

View from front of barbecue

Figure 25

To lower table: Pull support rod up to disengage slide lock, and lower table. To raise table, lift table up and engage slide in locked position. Figure 26.

Support rod

View from rear of barbecue

Slide

Unlocked position

Locked position

Figure 26

Step 21

Install right hand swing table

You will need: swing table end bracket, two 10-24 hex nuts, two 10-24 x 1 3/4 inch machine screws, right hand slide bar assembly, swing table, four nylon washers, screwdriver and pliers.

Allow the slide bar to hang down. Push the support rod into the lower support bracket. Figure 27 (a). Swing the rod up so you can slide the rod all the way inside the locking tab. Figure 27 (b). The rod should swing freely inside the locking tab. Figure 27 (c).

View from rear

(b)

(c)

Support rod

(a)

Slide bar assembly

Figure 27

20

Image 20
Contents Genesis 5000 Series LP GAS Units only Warranty Patents and Trademarks Contents For Installation in Canada General InstructionsStorage Operating areaStep AssemblyCheck package contents Page Page Check contents of hardware packs Assemble wheels Assemble frameContinue frame assembly Complete frame assemblyInsert casters Check the frame assemblyInstall left end panel Install the three back panels Install side burner locksAdd cooking box Install side burner Install manifold bracketInstall tank panel assembly Install right end panelAdd fuel scale Install bottom accessory traysInstall igniter Install left hand swing table Check that all burner valves are offInstall right hand swing table Hinge rod View from rear of barbecue Set LP fuel scale Fill LP tankConnect LP tank Check for gas leaks Insert Flavorizer Bars Steam-N-Chips Smoker Install cooking grates Install the bottom trayInstall the lid Install glass doors Secure side burnerComplete accessory installation Lighting To ExtinguishManual Lighting Side burner will only operate when the Front burner is lit Lighting the side burnerPeriodic Cleaning CookingStorage and/or Nonuse Storage and/or NonuseUsing the Steam-N-Chips Smoker To use the Steam-N-Chips SmokerRefilling the LP tank Removal of the LP tankEngaged Safe handling tips for LP Gas Liquid Propane LP TanksAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsGeneral Maintenance Main Burner Cleaning ProcedureWeber Spider Stopper Guards Main Burner Flame PatternView from behind cooking box Wing nuts Crossover Ignition System Operations FlameCheck Safety System When burner is on HIGH. Flames do not run Burner does not light, or flame is low in High positionBurner flame pattern is erratic. Flame is low Resembles paint peelingSide Burner Troubleshooting Side Burner MaintenanceProblem Check Cure Side burner does not light Flame is low in High positionPage 19-20 22-24 Parts List Final Word Thanks
Related manuals
Manual 44 pages 20.87 Kb