DeWalt AP400 instruction manual Side Supports, Attaching Motor and Blower Assembly to Frame

SIDE SUPPORTS

1.Place the dust collector base (A) Fig. 5, in an upright position as shown.

2.Align the two holes in the wider end of the side support (B) Fig. 5 with the two holes (C) in the base.

3.Insert a 5/16-18x3/4" hex head screw (A) Fig. 6 thru each hole in the side support and base.

4.Place a 5/16" lockwasher onto the hex head screw.

5.Thread a 5/16-18 hex nut onto the hex head screw and tighten securely.

6.Repeat this process for the remaining side support.

7.Fig. 7 shows both side supports (A) attached to the base (B).

ATTACHING MOTOR AND BLOWER ASSEMBLY TO FRAME

1.Place motor assembly and base assembly on their side.

2.Align the four holes, two shown at (C), on the top of the side supports (A) Fig. 8, with the four holes in the motor assembly (B).

3.Place a 5/16" lockwasher onto a 5/16-18x3/4" hex head screw and insert the bolt thru the side support and thread bolt into the tapped hole in the motor assembly and tighten securely.

4.Repeat this process for the three remaining holes.

5.Fig. 9 shows the motor and blower assembly attached to the side supports.

A

B

C

Fig. 5

A

Fig. 6

AA

B

Fig. 7

B

A

A

C

Fig. 8

10