Craftsman 152.213371 operating instructions Inlet U and tighten 6-inch hose clamp

5, Align the hobs in the drum support with the hobs in the drum (M), Place a 5/16" lock washer on a 5/16- 18 x 5/8" hex head screw, then 5/16" fiat washer onto the hex head screw, insert the hex head screw

thru the hob in drum support and drum, Thread a 5/16" hex nut onto the hex head screw and tighten securely, See figure 11, Fasten the remaining drum supports to the drum in the same manner,

Fig. 12

T

4, Assemble U-Bracket (H) to Drum (J), Place a 5/16" lock washer then a 5/16" fiat washer onto a 5/16-

18 x 5/8" hex head screw (K) thru the hob in the U-Bracket and the hob in the drum, thread a 5/16" hex nut onto the hex head screw, Repeat this

process for the remaining hob and securely tighten both screws, NOTE: U-Bracket should be mounted

to the right side of opening (L) in the drum as shown, See figure 10,

8, Place one end of 6°inch diameter flexible hose (N)

Fig. 11over blower/motor outlet(R), Slide one 6°inch diameter hose clamp (S) down 6°inch flexible hose and tighten hose clamp to blower/motor outlet, See figure 12,

ME	Place	the other 6-inch hose		clamp (T) over the
7,
	6-inch flexible hose, Attach			the 6-inch flexible hose
	to the	drum	inlet (U) and tighten 6-inch hose clamp,
	See figure		12,

12