Woodstock W1688 instruction manual

Page 2

WARNING

Some dust created by power sanding, sawing, grind- ing, drilling, and other construction activities con- tains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

Lead from lead-based paints.

Crystalline silica from bricks, cement, and other masonry products.

Arsenic and chromium from chemically treated lumber.

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well venti- lated area, and work with approved safety equip- ment, such as those dust masks that are specially designed to filter out microscopic particles.

Image 2
Contents Edge Sander Page Table of Contents About Your New Edge Sander Woodstock Service and SupportIntroduction Warranty and Returns SpecificationsDisconnect machine when cleaning, adjusting or servicing SafetyStandard Safety Instructions Keep machine away from open flame Habits-good and bad-are hard to breakAdditional Safety Instructions for Edge Sanders Keep fingertips away from the moving sanding beltAvoiding Potential Injuries Do not hold wood away from the backExtension Cords 220V OperationGrounding 110V Operation Typical Nema 5-20 plug and receptacleThis Page Intentionally Left Blank Unpacking AssemblyBox Contents Shop Preparation Cleaning BeginningMain Table To install the main table, do these stepsFeet Main table-tilt lock levers and scale Miter Gauge To install the quick release lever, do these stepsQuick Release Lever Sanding Belt To install the sanding belt, do these stepsDust Hood Sanding-belt quick release lever Normal operating position Auxiliary Table To install the auxiliary table, do these stepsBack Stop Adjustments Vertical Belt TrackingDiagonal Belt Tracking Diagonal belt trackingPlaten-to-Roller Alignment Platen and retaining boltsBelt Tension Hex nut and belt tension rodTo adjust the table height, do these steps Main Table HeightMain Table Tilt Do not loosen both table tilt lock Levers at the same timeOperations Starting the SanderPlaten Tilting Incorrectly holding and tilting PlatenVertical Sanding Set the workpiece on the tableOperation Horizontal Sanding Incorrect face sanding away from Back stopContour Sanding Set the workpiece on the auxiliary tableTroubleshooting Troubleshooting Operation This Page Intentionally Left Blank General MaintenanceLubrication Cleaning Table and BaseW1688 Edge Sander Wiring Diagram Closure 6450 101 14 65 Description Tilt Plate Your Notes Your Notes BOX BELLINGHAM, WA Warranty Card