Woodstock W1688 Dust Hood, Sanding Belt, To install the sanding belt, do these steps

Page 18

ASSEMBLY

Dust Hood

When connected to a dust collection system, the dust hood directs suction to remove harmful wood and abrasive dust from your work area. For additional information on the correct dust collection system, additions, or modifications; contact your Woodstock International dealer for your copy of the Dust Collection Basics hand- book and available accessories.

DO NOT operate this machine without the cor- rect dust collection sys- tem. Failure to use a dust collection system can result in short and long- term respiratory illness.

To connect dust hood, do these steps:

1.Locate your dust edge sander where it will be used

2.Connect your dust collection suction tube to the dust port, so when you tilt the platen from the vertical to the horizontal position, the suction tube will not bind, leak, or dis- connect the dust-collector ducting ground. See Figure 20.

Dust Port

Figure 20. Platen and dust hood tilt.

Quick Release Lever

Dust Hood Cover

in Unlocked Position

 

Belt

 

Tracking

 

Lock

 

Knob

 

Figure 21. Belt tracking lock knob, dust port

cover, and quick release lever.

Sanding Belt

Your Model W1688 Edge Sander is shipped with a general purpose sanding belt great for most woodworking needs. With proper care, machine operation, and dressing the belt with the use of a PRO-STIK®belt cleaner available through your Woodstock International dealer, your edge sander belt will enjoy extended service life.

To install the sanding belt, do these steps:

1.Loosen the belt tracking lock knob. See

Figure 21.

2.Unlatch and open the dust port cover. See

Figure 21.

-16-

Arrows Must Point this

Direction

Figure 22. Sanding belt directional installa-

tion.

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Edge Sander Page Table of Contents Woodstock Service and Support IntroductionAbout Your New Edge Sander Warranty and Returns SpecificationsSafety Standard Safety InstructionsDisconnect machine when cleaning, adjusting or servicing Keep machine away from open flame Habits-good and bad-are hard to breakAdditional Safety Instructions for Edge Sanders Keep fingertips away from the moving sanding beltAvoiding Potential Injuries Do not hold wood away from the back220V Operation GroundingExtension Cords 110V Operation Typical Nema 5-20 plug and receptacleThis Page Intentionally Left Blank Assembly Box ContentsUnpacking Shop Preparation Cleaning BeginningTo install the main table, do these steps FeetMain Table Main table-tilt lock levers and scale To install the quick release lever, do these steps Quick Release LeverMiter Gauge To install the sanding belt, do these steps Dust HoodSanding Belt Sanding-belt quick release lever Normal operating position To install the auxiliary table, do these steps Back StopAuxiliary Table Adjustments Vertical Belt TrackingDiagonal Belt Tracking Diagonal belt trackingPlaten-to-Roller Alignment Platen and retaining boltsBelt Tension Hex nut and belt tension rodTo adjust the table height, do these steps Main Table HeightMain Table Tilt Do not loosen both table tilt lock Levers at the same timeOperations Starting the SanderPlaten Tilting Incorrectly holding and tilting PlatenVertical Sanding Set the workpiece on the tableOperation Horizontal Sanding Incorrect face sanding away from Back stopContour Sanding Set the workpiece on the auxiliary tableTroubleshooting Troubleshooting Operation This Page Intentionally Left Blank General MaintenanceLubrication Cleaning Table and BaseW1688 Edge Sander Wiring Diagram Closure 6450 101 14 65 Description Tilt Plate Your Notes Your Notes BOX BELLINGHAM, WA Warranty Card
Top Page Image Contents