Woodstock W1688 Avoiding Potential Injuries, Do not hold wood away from the back

Page 9

Avoiding Potential Injuries

Back Stop

Back Stop

SAFETY

Figure 1. DO NOT hold wood away from the back

 

Figure 2. ALWAYS use the back stop, and keep

stop, and keep your fingers away from the belt.

 

your fingers away from the belt.

 

 

 

 

 

 

 

 

 

 

 

 

Figure 3. DO NOT sand wood with your fingers

 

Figure 4. ALWAYS keep your fingers away from

close to the idler roller and belt.

 

the idler roller and the belt.

 

 

 

 

 

 

 

 

 

 

 

 

Figure 5. DO NOT sand wood with sharp corners

Figure 6. ALWAYS sand wood with sharp corners

at the leading-edge of the sanding operation. The

at the trailing-edge of the sanding operation.

belt can grab and throw the wood.

-7-

Image 9
Contents Edge Sander Page Table of Contents Woodstock Service and Support IntroductionAbout Your New Edge Sander Specifications Warranty and ReturnsSafety Standard Safety InstructionsDisconnect machine when cleaning, adjusting or servicing Habits-good and bad-are hard to break Keep machine away from open flameKeep fingertips away from the moving sanding belt Additional Safety Instructions for Edge SandersDo not hold wood away from the back Avoiding Potential Injuries220V Operation GroundingExtension Cords Typical Nema 5-20 plug and receptacle 110V OperationThis Page Intentionally Left Blank Assembly Box ContentsUnpacking Beginning Shop Preparation CleaningTo install the main table, do these steps FeetMain Table Main table-tilt lock levers and scale To install the quick release lever, do these steps Quick Release LeverMiter Gauge To install the sanding belt, do these steps Dust HoodSanding Belt Sanding-belt quick release lever Normal operating position To install the auxiliary table, do these steps Back StopAuxiliary Table Vertical Belt Tracking AdjustmentsDiagonal belt tracking Diagonal Belt TrackingPlaten and retaining bolts Platen-to-Roller AlignmentHex nut and belt tension rod Belt TensionMain Table Height To adjust the table height, do these stepsDo not loosen both table tilt lock Levers at the same time Main Table TiltStarting the Sander OperationsIncorrectly holding and tilting Platen Platen TiltingSet the workpiece on the table Vertical SandingOperation Incorrect face sanding away from Back stop Horizontal SandingSet the workpiece on the auxiliary table Contour SandingTroubleshooting Troubleshooting Operation This Page Intentionally Left Blank Lubrication Cleaning MaintenanceGeneral Table and BaseW1688 Edge Sander Wiring Diagram Closure 6450 101 14 65 Description Tilt Plate Your Notes Your Notes BOX BELLINGHAM, WA Warranty Card