Quick Release Lever in |
Normal Operating Position |
Figure 23. Sanding-belt quick release lever in
the normal operating position.
Belt Tracking Knob
Belt Tracking Lock Knob
Figure 24. Belt-tracking lock knob.
3.Move the quick release lever to the unlocked position so it drops into the lock groove. See
Figure 23.
4.Locate the arrows printed on the inside of the sanding belt that indicate direction or belt rotation. See Figure 22.
5.Slide the sanding belt over the pulleys so that the belt rotation (shown with arrows on the inside of belt) matches the
Keep your machine unplugged during all assembly, adjustments, or maintenance proce- dures. Otherwise serious personal injury may occur!
6.Position the belt so it is centered on the plat- en and pulleys and is in the normal operating position. See Figure 23.
7.Close and latch shut the dust port cover.
8.Move the quick release lever out of the lock groove so the idler pulley applies tension to the sanding belt, and the quick release lever rests in the normal operating position. See
Figure 23.
9.With the sander unplugged, carefully use your hand to rotate the sanding belt a few rotations in the operating direction to make sure the belt stays in the normal operation position.
•If the belt tracks to high or to low, go to Page 19 and adjust the vertical belt track- ing so the belt tracks in the center.
•If the belt tracks diagonally, go to Page 20 and adjust the diagonal belt tracking so the belt tracks horizontally.
10.Tighten the belt tracking lock knob if the belt tracks correctly. See Figure 24.
ASSEMBLY