OPERATIONS
Starting the Sander
ALWAYS take a few moments to listen and observe for unusual noise and vibration after starting the edge sander.
Figure 40. ON/OFF switch in the ON position.
MODEL W1688
EDGE SANDER
INSTRUCTION MANUAL
Phone: 1-360-734-3482 • On-Line Technical Support: shopfox.biz
COPYRIGHT © SEPTEMBER, 2002 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. | Printed in Taiwan |
DO NOT start this sander until you have complet- ed all assembly, adjust- ments, safety require- ments, and you have read and understand this entire manual.
Figure 41. Ready for emergency shut down.
Figure 42. Safety lockout key removed.
Always wear a dust mask and safety glasses when operating this machine. Sawdust may cause aller- gicreactions or respiratory problems.
Make sure loose clothing and long hair is secured and kept away from moving parts.
To start the edge sander, do these steps:
1.Pull the ON/OFF switch up. See Figure 40.
2.Position your finger over the ON/OFF switch so you are ready to shut the sander OFF if there is a problem. See Figure 41.
3.Listen for any unusual noises. The sander must run smoothly with little or no vibration.
4.If unusual noise or vibration exists, shut the sander off immediately. DO NOT restart the sander until you correct the problem.
5.Remove the safety lockout key and unplug the sander, troubleshoot the source of the noise or vibration, and correct the problem. DO NOT make any adjustments to the sander while it is plugged in. See Figure 42.
OPERATION