Woodstock W1688 instruction manual Standard Safety Instructions

Page 6

SAFETY

SAFETY

READ MANUAL BEFORE OPERATING MACHINE. FAILURE TO FOLLOW INSTRUCTIONS BELOW WILL RESULT IN PERSONAL INJURY.

Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided, COULD result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided, MAY result in minor or moderate injury and/or damage to the machinery.

This symbol is used to alert the user to useful information about proper NOTICE operation of the equipment.

Standard Safety Instructions

1.Thoroughly read the instruction manual before operating your machine. Learn the applications, limitations and potential hazards of this machine. Keep manual in a safe, convenient place for future reference.

2.Keep work area clean and well lighted. Clutter and inadequate lighting invite potential hazards.

3.Ground all tools. If a machine is equipped with a three-prong plug, it must be plugged into a three- hole grounded electrical receptacle or grounded extension cord. If using an adapter to aid in accom- modating a two-hole receptacle, ground using a screw to a known ground.

4.Wear eye protection at all times. Use safety glasses with side shields or safety goggles that meet the national safety standards, while operating this machine.

5.Avoid dangerous environments. Do not operate this machine in wet or open flame environments. Airborne dust particles could cause an explosion and severe fire hazard.

6.Ensure all guards are securely in place and in working condition.

7.Make sure switch is in the OFF position before connecting power to machine.

8.Keep work area clean, free of clutter, grease, etc.

9.Keep children and visitors away. Visitors should be kept at a safe distance while operating unit.

10.Childproof workshop with padlocks, master switches or by removing starter keys.

11.Disconnect machine when cleaning, adjusting or servicing.

-4-

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Edge Sander Page Table of Contents Woodstock Service and Support IntroductionAbout Your New Edge Sander Warranty and Returns SpecificationsSafety Standard Safety InstructionsDisconnect machine when cleaning, adjusting or servicing Keep machine away from open flame Habits-good and bad-are hard to breakAdditional Safety Instructions for Edge Sanders Keep fingertips away from the moving sanding beltAvoiding Potential Injuries Do not hold wood away from the back220V Operation GroundingExtension Cords 110V Operation Typical Nema 5-20 plug and receptacleThis Page Intentionally Left Blank Assembly Box ContentsUnpacking Shop Preparation Cleaning BeginningTo install the main table, do these steps FeetMain Table Main table-tilt lock levers and scale To install the quick release lever, do these steps Quick Release LeverMiter Gauge To install the sanding belt, do these steps Dust HoodSanding Belt Sanding-belt quick release lever Normal operating position To install the auxiliary table, do these steps Back StopAuxiliary Table Adjustments Vertical Belt TrackingDiagonal Belt Tracking Diagonal belt trackingPlaten-to-Roller Alignment Platen and retaining boltsBelt Tension Hex nut and belt tension rodTo adjust the table height, do these steps Main Table HeightMain Table Tilt Do not loosen both table tilt lock Levers at the same timeOperations Starting the SanderPlaten Tilting Incorrectly holding and tilting PlatenVertical Sanding Set the workpiece on the tableOperation Horizontal Sanding Incorrect face sanding away from Back stopContour Sanding Set the workpiece on the auxiliary tableTroubleshooting Troubleshooting Operation This Page Intentionally Left Blank General MaintenanceLubrication Cleaning Table and BaseW1688 Edge Sander Wiring Diagram Closure 6450 101 14 65 Description Tilt Plate Your Notes Your Notes BOX BELLINGHAM, WA Warranty Card
Top Page Image Contents