Woodstock W1688 instruction manual Your Notes

Page 43

YOUR NOTES

Image 43

Contents Edge Sander Page Table of Contents Introduction Woodstock Service and SupportAbout Your New Edge Sander Specifications Warranty and ReturnsStandard Safety Instructions SafetyDisconnect machine when cleaning, adjusting or servicing Habits-good and bad-are hard to break Keep machine away from open flameKeep fingertips away from the moving sanding belt Additional Safety Instructions for Edge SandersDo not hold wood away from the back Avoiding Potential InjuriesGrounding 220V OperationExtension Cords Typical Nema 5-20 plug and receptacle 110V OperationThis Page Intentionally Left Blank Box Contents AssemblyUnpacking Beginning Shop Preparation CleaningFeet To install the main table, do these stepsMain Table Main table-tilt lock levers and scale Quick Release Lever To install the quick release lever, do these stepsMiter Gauge Dust Hood To install the sanding belt, do these stepsSanding Belt Sanding-belt quick release lever Normal operating position Back Stop To install the auxiliary table, do these stepsAuxiliary Table Vertical Belt Tracking AdjustmentsDiagonal belt tracking Diagonal Belt TrackingPlaten and retaining bolts Platen-to-Roller AlignmentHex nut and belt tension rod Belt TensionMain Table Height To adjust the table height, do these stepsDo not loosen both table tilt lock Levers at the same time Main Table TiltStarting the Sander OperationsIncorrectly holding and tilting Platen Platen TiltingSet the workpiece on the table Vertical SandingOperation Incorrect face sanding away from Back stop Horizontal SandingSet the workpiece on the auxiliary table Contour SandingTroubleshooting Troubleshooting Operation This Page Intentionally Left Blank Table and Base MaintenanceLubrication Cleaning GeneralW1688 Edge Sander Wiring Diagram Closure 6450 101 14 65 Description Tilt Plate Your Notes Your Notes BOX BELLINGHAM, WA Warranty Card