2.Insert the two M10x25 socket head cap screws (AA), with two M10 flat washers (EE), through the fence base and into the threaded holes on the pivot plate, as shown in Figure 9.
3.Tighten the screws with an 8mm hex wrench.
4.Check that the gap between fence and sanding belt is about 1/16”. If it is greater than 1/16”, loosen (do not remove) the four screws on the sides of the fence assembly with a hex wrench, and push the fence toward the belt until the proper gap is attained.
5.
See under “Adjustments” for further instruction on adjusting the fence.
Installing Abrasive Disc
Refer to Figure 10:
1.Loosen the two screws on the front panel with a 10mm wrench, and pull out on the front panel. The front panel will not remove from the sander, but this will allow more room for positioning the abrasive disc.
2.Remove the backing from the abrasive disc to expose the adhesive, and carefully center it on the sander’s metal disc. Press the abrasive disc firmly, working from the center out to prevent creases or air bubbles.
3.Tighten the two screws on the front panel.
When removing an old abrasive disc, use mineral spirits or a similar cleaning product to remove any residual adhesive from the sander’s metal disc before installing a new abrasive.
Installing Table
Refer to Figure 11:
1.On both sides of the sander body, loosen the locking wheels (A), and pull the trunnion holders (B) out far enough to allow clearance between trunnion holders and sander body.
2.Install the table by sliding the table trunnions into the slots of the trunnion holders. See Figure 11 inset. Be careful not to damage the angle pointer on the left trunnion holder.
3.Slide the trunnion holders (B) back in, and
See under “Adjustments” for further instruction on adjusting the table.
Figure 9
Figure 10
Figure 11
12