DMX Addressing | Elation Professional 575B specification

Design Spot 575B™

10. DMX ADDRESSING

Setting the DMX address - After the fixture is turned “ON” it will immediately complete a reset process that test all the fixture’s functions. When the reset process concludes the LCD will display the fixture’s current DMX address. If the fixture is not receiving a DMX signal, the display will flash continuously. To set or adjust a DMX address, please follow the procedure below:

1.Toggle through the menu by pressing the Up and Down buttons until the display reads “Set DMX Address.” Tap the enter button to make changes to the address.

2.While the current three-digit address is flashing use the “UP” and “DOWN” buttons to select a new address. Once the new address has been selected, lock the new address into the fixture’s memory by pressing the “ENTER” button.

The DMX address is non-volatile and will remain in the fixture’s memory even when the power to the unit is switched off. Memory is backed-up and retain by an internal power source that should last about five years

Remote DMX addressing (RDMX) / Address Via DMX- This function allows the DMX address to be changed remotely from a DMX console. This setting requires special settings for both the controller and the fixture. RDMX is on by default. Follow the procedure listed below to access the RDMX functions:

Fixture Settings:

1.Access the main menu and use the UP or DOWN to get to the “Personality”

menu, then press ENTER.

2. Once in the “Personalities” menu, tap the UP or Down to get to the “Status Settings “ menu, press ENTER.

3.Once in the “Status Settings” tap the UP or Down to get to the “Address via DMX” function and press ENTER.

4.“Address via DMX” is the function that turn the RDMX function on and off.

5.Press the UP button to display “ON” to activate this function, or “OFF” to deactivate this function.

6.Press ENTER to confirm.

Design Spot 575B™