
Carbide Cutter
To Outfeed
Table Alignment
(Models G9953ZX, G9953ZXF and G4815)
The outfeed table must be perfectly level with the carbide cutters.
To verify the factory setting:
1.Unplug the machine from the power source!
2.Open the access door (Figure 17) on the back of the machine, just below the fence adjustments .
Access Door
Cutterhead Pulley
Figure 17. Accessing the cutterhead pulley.
3.Position the edge of a straightedge on the outfeed table so that it extends over the cut- terhead (Figure 18).
Carbide cutter |
is at the highest |
point in its revo- |
lution and is just |
touching the |
straightedge. |
Outfeed Table |
Figure 18. Verifying outfeed table height with
straightedge.
4.Rotate the cutterhead by turning the cutter- head pulley (Figure 17).
5.Watch as one of the carbide cutters passes under the straightedge. The carbide cutter should just touch the straightedge WITHOUT lifting the it off the outfeed table. If this condi- tion is not present, refer to Section 8: Service Adjustments.
Ultimate Series Jointers |