ASSEMBLY INSTRUCTIONS/OPERATIONS
FIGURE 38.
11)If the Floor Planer is powered by an engine, reconnect the engine spark plug wire. If powered by an electric motor and the machine is to be used immediately, reconnect the extension cord or Floor Planer to the power source. Determine that the ON/OFF switch located on the operator handle is in the OFF position.
DANGER
UNEXPECTED MACHINE START UP CAN RESULT IN PROPERTY DAMAGE AND/OR PERSONAL INJURY.
INSTALLING A REPLACEMENT BEARING ON THE
Application: All Models.
Tools Required:
1each, 9/16 inch wrench.
1each, 7/16 inch wrench.
1each, torque wrench, 35 ft lbs (47 Nm.) capacity with 9/16 inch socket.
1each, 5/16 inch Allen wrench.
1each, pliers for large, external type snap rings.
1each, shop press.
Parts Required:
1 each, PN
1each, container of bearing and shaft locking grade, anaerobic adhesive/sealant.
1each, PN
1each, PN
1)If the Floor Planer is powered by an engine, disconnect the spark plug wire. If powered by an electric motor, disconnect the extension cord or Floor Planer from the power source.
2)Position the Floor Planer on a suitable work surface with the
3)Using the 9/16 inch wrench, remove the belt guard
from the main frame. Clean the inside of the belt guard with an appropriate solvent. Check for signs of wear and damage.
CAUTION
Observe all applicable safety precautions for the solvent.
4)Remove the
INSTALLING A REPLACEMENT
5)Using the 5/16 inch Allen wrench and 9/16 inch wrench, remove the bearing block/driveshaft assembly from the main frame. For accuracy and alignment purposes, the main frame incorporates tapped holes to properly position the capscrews.
6)Position the driveshaft assembly on a suitable work surface. Use the snap ring pliers to remove the snap ring. FIGURE 39. Remove the spacer.
CAUTION
Wear safety glasses and other appropriate safety apparel when removing the snap ring or performing any work with an arbor press. Caution all onlookers about the possibility of flying debris and personal injury.
7)Position the driveshaft assembly in a suitable arbor press. Determine that the outer race of the bearing is properly supported. Press the bearing/driveshaft assembly from the bearing block. FIGURE 40. Reposition the assembly and press the bearing from the bearing block. FIGURE 41.
FIGURE 39
8FP FLOOR PLANER SERIES | OPERATION AND PARTS MANUAL REV #2 (05/28/09) | PAGE 35 |
|
|
|