SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov- ice machine operator with a basic understanding of how the machine is used during operation, so the machine controls/components discussed later in this manual are easier to understand.
Due to the generic nature of this overview, it is not intended to be an instructional guide. To learn more about specific operations, read this entire manual and seek additional training from expe- rienced machine operators, and do additional research outside of this manual by reading "how- to" books, trade magazines, or websites.
To reduce your risk of serious injury, read this entire manual BEFORE using machine.
Damage to eyes, respiratory system, or feet could result from using this machine with- out proper protection. Always wear eye pro- tection, respirator, and leather boots with extra toe protection.
To complete a typical operation, the operator does the following:
1.Examines the grinding wheel to make sure it is suitable for use.
2.Examines the workpiece to make sure it is properly prepared for grinding.
3.Uses the
4.Uses the magnetic chuck to hold the workpiece to the table, then turns the
5.Turns the grinder ON, then waits until the wheel reaches full speed.
6.Performs the grinding operation.
Note: Because the method for perform- ing each grinding operation varies, specific actions are not listed here.
7.When the grinding operation is complete, turns the grinder OFF and allows the grinding wheel to come to a complete stop.
8.Removes the workpiece from the table.
If you are not experienced with this type of machine, WE STRONGLY RECOMMEND that you seek additional training outside of this manual. Read books/magazines or get formal training before beginning any proj- ects. Regardless of the content in this sec- tion, Grizzly Industrial will not be held liable for accidents caused by lack of training.
Model G0763 (Mfg. Since 8/13) |