Grizzly G0763 owner manual Cable orientation on pulley Open End Pulley

6.Assemble ball bearing segments into two strips of equal size (four segments each).

7.Apply medium coat of NLGI#2 grease to ball bearing strips.

8.Position ball bearing strips in middle of sad- dle ways, as shown in Figure 16.

Ball Bearing Strips

Figure 16. Ball bearing strips positioned on

saddle ways.

9.With the help of another person, gently place table right side up on ball bearing strips.

10.Feed table cable under table so that attached cable barrel is on the right of machine, as shown in Figure 17.

x 1

Cable Barrel

Figure 17. Cable barrel attached.

11.Secure barrel to table with (1) M10-1.5 x 50 cap screw.

Model G0763 (Mfg. Since 8/13)

Note: When cable is properly wrapped around pulley in next step, have another person maintain enough tension on cable so that it stays in pulley grooves until it can be secured in following steps.

12.Wrap cable around pulley twice, as shown in Figures 18–19.

Note: Pay close attention to position and orientation of cable on pulley, as illustrated in Figure 18.

Open End

of Pulley

To the

Right End

To the

Left End

Figure 18. Cable orientation on pulley.

Open End

of Pulley

Figure 19. Cable on pulley, as viewed from left

end of table.

13.While maintaining cable tension, move table back and forth several times to ensure cable position on pulley allows full travel of table.

—If the cable position on the pulley does not allow full travel of table, reposition cable on pulley until it does.

-19-