Repair | P 11 / 22 |
< 10 > Disassembling tool holder guide section
( 1 ) After removing change lever ( See page 9), separate gear housing from motor housing as illustrated in Fig. 40 and Fig. 41 in page 10.
( 2 ) Remove inner housing as illustrated in Fig. 44.
( 3 ) Separate tool holder guide section from inner housing. See Fig. 45.
( 4 ) Remove ring spring 29, while pressing washer 31 which covers ring spring 29, toward the spur gear 51 side. See Fig. 46 and 47. After removing ring spring 29, reduce pressure on the washer 31 slowly.
( 5 ) Remove washer 31, compression spring 32 and spur gear 51 form tool holder guide. See Fig. 48.
Tool holder guide section
Inner housing
Flat washer 28 Piston cylinder
Tool holder guide section
Inner housing
Swash bearing
section
Fig. 44
Swash bearing section
Fig. 45
No. 1R306 Ring spring extractor
Round bars 
for arbor
Ring 
spring 29
Washer 31
Retaining ring
plier
Fig. 46
Ring 
spring 29
Retaining | Washer 31 | |
ring plier | ||
| ||
Fig. 47 |
|
Washer 31
Compression spring 32
Spur gear 51
Tool 
holder guide 
Fig. 48
< 11 > Assembling tool holder guide section
( 1 ) Apply grease to spur gear 51 and tool holder guide referring to "< 2 > Lubrication to the machine parts" in page 3.
( 2 ) Mount spur gear 51, compression spring 32 and washer 31. See Fig. 48.
( 3 ) Pressing the washer 31 toward the spur gear 51 side, with arbor press, mount ring spring 29 as illustrated in Fig. 47 and Fig. 46. And mount flat washer 28 to the position illustrated in Fig. 45.
( 4 ) Insert piston cylinder of swash bearing section into tool holder guide. And insert tool holder section into inner housing as illustrated in Fig. 45.