Miller Electric 350, 350P, Millermatic 350 manual Drive Roll And Wire Guide Kits

SECTION 8 − PARTS LIST

8-1. Drive Roll And Wire Guide Kits

.Base selection of drive rolls upon the following recommended usages:

1V-Grooved rolls for hard wire.

2U-Grooved rolls for soft and soft shelled cored wires.

3U-Cogged rolls for extremely soft shelled wires (usually hard surfacing types).

4V-Knurled rolls for hard shelled cored wires.

5Drive roll types may be mixed to suit particular requirements (e.g. V-Knurled roll in combination with U-Grooved).

	Wire Diameter			Kit No.	Drive Roll		Wire Guide
Fraction		Decimal	Metric		Part No.	Type	Inlet	Intermediate
.023/.025 in		.023/.025 in	0.6 mm	087 132	087 130	V-Grooved	056 192	056 206
.030 in		.030 in	0.8 mm	046 780	053 695	V-Grooved	056 192	056 206
.035 in		.035 in	0.9 mm	046 781	053 700	V-Grooved	056 192	056 206
.045 in		.045 in	1.2 mm	046 782	053 697	V-Grooved	056 193	056 207
.052 in		.052 in	1.3 mm	046 783	053 698	V-Grooved	056 193	056 207
1/16 in		.062 in	1.6 mm	046 784	053 699	V-Grooved	056 195	056 209
.035 in		.035 in	0.9 mm	044 750	072 000	U-Grooved	056 192	056 206
.045 in		.045 in	1.2 mm	046 785	053 701	U-Grooved	056 193	056 207
.052 in		.052 in	1.3 mm	046 786	053 702	U-Grooved	056 193	056 207
1/16 in		.062 in	1.6 mm	046 787	053 706	U-Grooved	056 195	056 209
.035 in		.035 in	0.9 mm	046 792	132 958	V-Knurled	056 192	056 206
.045 in		.045 in	1.2 mm	046 793	132 957	V-Knurled	056 193	056 207
.052 in		.052 in	1.3 mm	046 794	132 956	V-Knurled	056 193	056 207
1/16 in		.062 in	1.6 mm	046 795	132 955	V-Knurled	056 195	056 209

Ref. S-0025-D

.A complete Parts List is available at www.MillerWelds.com

OM-1327 Page 52