Miller Electric Bobcat 225 Installation, Installing Welding Generator, Mounting, Frame as shown

. A complete Parts List is available at www.MillerWelds.com

SECTION 5 − INSTALLATION

5-1. Installing Welding Generator

Movement

! Do not lift unit from end.

OR

Location / Airflow Clearance

	OR
	18 in
	(460 mm)
	18 in
18 in	(460 mm)

(460 mm)
18 in	18 in
	(460 mm)
(460 mm)

Mounting

OR

Inadequate support.

! Do not use flexible mounts. 1

Grounding 2		!	Bed liners, shipping skids, and some running gears in-
	3
GND/PE			sulate the welding generator from the vehicle frame. Al-
			ways connect a ground wire from the generator equip-
			ment grounding terminal to bare metal on the vehicle
			frame as shown.

Electrically bond generator frame to vehicle frame by metal-to-metal contact.

! Do not weld on base. Welding on base can cause fuel tank fire or explosion. Bolt unit down using holes provided in base.

! Always securely fasten weld-

ing generator onto transport vehicle or trailer and comply with all DOT and other applica- ble codes.

! Do not mount unit by support- ing the base only at the four mounting holes. Use cross- supports to adequately sup- port unit and prevent damage to base.

! Always ground generator frame to vehicle frame to pre- vent electric shock and static electricity hazards.

! If unit does not have GFCI re- ceptacles, use GFCI-protected extension cord.

NOTICE − Do not install unit where air flow is restricted or engine may overheat.

Mounting:

1 Cross-Supports

Mount unit on flat surface or use cross-supports to support base.

Grounding:

2Equipment Grounding Terminal (On Front Panel)

3Grounding Cable (Not Supplied)

4Metal Vehicle Frame

Connect cable from equipment ground terminal to metal vehicle frame. Use #10 AWG or larger insu- lated copper wire.

4 install2 12/06 − Ref. 800 652 / Ref. 800 477-A / 803 274-A / 804 712

OM-4434 Page 17