Miller Electric Bobcat 225 manual Optional Generator Power Receptacles, Breaker trips

. A complete Parts List is available at www.MillerWelds.com

7-2. Optional Generator Power Receptacles

	!	If unit does not have GFCI recep-
		tacles, use GFCI-protected exten-
		sion cord.
	. Generator power decreases as weld
		current increases.
		Set Fine Control R1 at 10 for full genera-
1		tor power.
	Combined output of all receptacles limited to
	10 kVA/kW rating of the generator.
	CSA/GFCI Receptacle Option
	1	120 V 20 A AC GFCI Receptacles
		GFCI-2 and GFCI-3
	GFCI2 and GFCI3 supply 60 Hz single-
	phase power at weld/power speed. Maxi-
	mum output from GFCI-2 or GFCI-3 is 2.4
	kVA/kW. Circuit protection is the same as
	standard receptacles.
	If a ground fault is detected, the GFCI Reset
	button pops out and the circuit opens to dis-
	connect the faulty equipment. Check for
	damaged tools, cords, plugs, etc. con-
	nected to the receptacle. Press button to re-
	set receptacle and resume operation.
	!	Power is still present at the 240 volt
		receptacle when only one circuit

breaker trips.

Unplug power cord before attempt- ing to service accessories or tools.

. At least once a month, run engine at weld/power speed and press Test but- ton to verify GFCI is working properly.

Ref. 228 199-A

Notes

Work like a Pro!

Pros weld and cut safely. Read the safety rules at the beginning of this manual.

OM-4434 Page 31