English
KEYED CHUCK INSTALLATION (FIG. 4)
Screw the chuck on by hand as far as it will go. Insert the shorter end of a hex key and strike it in the clockwise direction with a soft hammer.
MAINTENANCE
Your DEWALT power tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of injury, turn unit off and disconnect tool from power source before installing and removing accessories, before making any adjustments or removing/installing attachments or accessories.
Motor Brushes
DEWALT uses an advanced brush system which automatically stops the drill when the brushes wear out. This prevents serious damage to the motor. New brush assemblies are available at authorized DEWALT service centers. Always use identical replacement parts.
Lubrication
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry air as often as dirt is seen collecting in and around the air vents. Wear approved eye protection and approved dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals for cleaning the
Accessories
WARNING: Since accessories, other than those offered by DEWALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only DEWALT, recommended accessories should be used with this product.
Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized service center.
CAUTION: To reduce the risk of injury, the following accessories should be used only in sizes up to the maximums shown in the table below.
MAXIMUM RECOMMENDED CAPACITIES
| DWD010 | DWD014 |
CHUCK CAPACITY | 6.5 mm | 10 mm |
BITS, METAL DRILLING | 6.5 mm | 10 mm |
WOOD, FLAT BORING | 15 mm | 25 mm |
| SPECIFICATIONS |
|
| ||
Voltage | 120 V~ | 120 V~ |
Frequency | ||
Power - watts | 380 W | 600 W |
RPM |
7