FIGURE 2
CC
English
A | A |
| |
B |
|
| D25201, D25203, |
D25101, D25103 | D25303, D25304 |
LOCK ON BUTTON (D25101, D25103 ONLY)
To lock the trigger switch in the ON position for continuous operation, depress the trigger switch and slide up the lock on button (B). The tool will continue to run.
To turn the tool OFF from a locked ON condition, squeeze once then release the trigger. Before using the tool each time, be sure that the lock on button release mechanism is working freely.
Do not lock the switch ON when drilling by hand so that you can instantly release the trigger switch if the bit binds in the hole. The lock on button is for use only when the rotary hammer is mounted in a drill press stand or otherwise held stationary.
CAUTION: Be sure to release the locking mechanism before disconnecting the plug from the power supply. Failure to do so will cause the rotary hammer to start immediately the next time it is plugged in. Damage or injury could result.
VARIABLE SPEED TRIGGER
The variable speed trigger switch (A) permits speed control. The farther the trigger switch is depressed, the higher the speed of the drill. NOTE: Use lower speeds for starting holes without a centerpunch, drilling in metal, plastics or ceramics, or driving screws. Higher speeds are better for drilling in masonry for maximum efficiency.
REVERSING LEVER
The reversing lever is used to reverse the rotary hammer for backing out screws or jammed bits. It is located above the trigger, shown in Figure 2.
D25101, D25103
To reverse the rotary hammer, turn it OFF and align the reversing lever
(C)with the yellow arrow pointing backward (viewed when holding drill in operating position).
To position the lever for forward operation, turn the rotary hammer OFF and align the reversing lever with the yellow arrow pointing forward (viewed when holding drill in operating position).
D25201, D25203, D25303, D25304
To reverse the rotary hammer, turn it OFF and push the reversing lever in so the yellow arrow pointing backwards shows.
To position the lever for forward operation, turn the rotary hammer OFF and push the reversing lever in so the yellow arrow pointing
forward shows.
CAUTION: When reversing to clear jammed bits, be ready for strong reactive torque.
Mode Selector – D25103, D25203, D25303, D25304 (Fig. 3)
CAUTION: Tool must come to a complete stop before activating the mode actuator button or damage to the tool may result.
4