English
ASSEMBLY
CAUTION: To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle.
NOTE:
When using tools such as bull points, cutters, etc., make sure to use the genuine parts designated by our company.
Grip (A)
A 
Tool
Shank
Front Cap
1. Installing Tools
(1)Clean the shank portion of the tool.
(2)As shown in Fig. 2, pull grip (A) in the direction of A, and insert the tool into a hole of the front cap.
(3)Adjust the groove position while turning the tool, and furthermore insert it until it hits the end of the hole.
(4)Return grip (A) to its original position, pull
the tool to make sure it is locked completely. (Fig. 3)
2.Deciding Working Position of Tool
The tool can be turned every 30 degrees and can be fixed at the position of 12 steps.
(1)As shown in Fig. 4, the blade angle can be freely changed if the grip (A) is turned in the direction of B in a state where grip
(B) is slid in the direction of A.
(2)Release grip (B) and turn the tool, and make sure that it is locked completely.
3.Removing Tool
As shown in Fig. 2, pull grip (A), and pull out the tool.
Fig. 2
Fig. 3
B
A
Grip (A)
Grip (B)
Fig. 4
10