Chauvet 1-TRI IP Setting Description, When R, G, and B are 255, the output will be at its maximum

Operation

Color Adjustment

Dimmer Curves

Control Panel Lock

Program Upload

Continued from previous page

The COLOR setting determines how the COLORado™ 1-Tri IP displays the white color when the Red, Green, and Blue faders are all at the “255” value.

1)Go to SET > Color.

2)Select OFF, RGBW, or UC.

Setting	Description
OFF	When R, G, and B are “255,” the output will be at its maximum.
RGBW	When R, G, and B are “255,” CAL2 will determine the output.
UC	When R, G, and B are “255,” the output will match that of fixtures from
	previous generations.

This setting determines how the output of the COLORado™ 1-Tri IP follows the position of the Dimmer fader, as well as the Red, Green, and Blue faders.

1)Go to SET > Dim.

2)Select a dimmer curve (Off, Dim1, Dim2, Dim3, or Dim4).

Setting	Description
OFF	The output is proportional to the faders’ position (linear)
Dim1	The output is not proportional (fastest)
Dim2	The output is not proportional (fast)
Dim3	The output is not proportional (slow)
Dim4	The output is not proportional (slowest)

This setting allows the user to activate or disable the control panel lock, which keeps non-authorized personnel from changing the fixture’s settings.

1)Go to KEY.

2)Select On/ Off.

When the control panel lock is active, the fixture will prompt the user to enter the password after 30 seconds of control panel inactivity or after turning on the fixture.

After being prompted to enter the password:

1)Press <UP>, <DOWN>, <UP>, <DOWN>, and <ENTER>.

This option allows the user to copy the custom programs of one COLORado™ 1-Tri IP fixture onto other COLORado™ 1-Tri IP fixtures by using the Master/Slave method.

1)Configure and connect the fixtures in a Master/Slave arrangement, where the master unit has the custom programs you want to transfer onto the slave units.

2)At the master unit, go to SET > UPLD.

3)When prompted, enter the master access password as shown in Control Panel Lock.

4)Wait for the upload process to finish before disconnecting the fixtures.

During and after the upload, the master and slave units will visually indicate the status of the process, as follows:

Color	Meaning
Yellow	The upload process is running
Red	The upload failed due to an error
Green	The upload finished successfully

Continues on the next page

COLORado™ 1-Tri IP User Manual Rev. 01c -11-